Loading ...
Loading ...
Loading ...
12 49-1000129 Rev. 2
Installation Instructions
INSTALLING THE REFRIGERATOR
Remove all protective film from the drawer fronts
before installing handles.
METHOD 1 - INSTALL TO COUNTERTOP
Attach the Anti-Tip Brackets
1. Pry hole covers from the top of the refrigerator
cabinet to reveal the holes used to install the
anti-tip brackets.
2. Open the upper drawer and leave it open to install
the anti-tip brackets.
3. Remove the anti-tip brackets and screws from the
accessory bag.
4. With the screws provided, fasten the anti-tip
brackets to both sides of the top of the cabinet.
Level the dual-drawer refrigerator
Adjustment of the leveling legs under the dual-drawer
may be necessary for a proper fit in the cabinet
opening.
1. Adjust the height of the rear of the dual-drawer
by raising or lowering the rear leveling legs, and
then begin to slide the dual-drawer into the under
counter opening.
2. Adjust the front of the dual-drawer, by raising or
lowering the leveling legs, until it fits under the
countertop, with enough space to install the anti-tip
bracket to the underside of the countertop.
3. Raise the front leveling legs until the anti-tip bracket
is flush with the underside of the countertop.
8VLQJDVFUHZSURYLGHGLQVWDOOGXDOGUDZHU
refrigerator to countertop.
HANDLE INSTALLATION
1. Remove the handle allen wrench from the
accessory bag located in the upper drawer.
2. Remove the handles from the top piece of the
packaging material. The handle with the badge
goes on the upper drawer, and the handle without a
badge goes on the lower drawer.
3. Loosen the set screw using the allen wrench.
Place the handle caps over the fasteners of the
door. Take care to support the handle so it doesn’t
fall and scratch the appliance finish. Make sure
both handle caps are resting on the face of the
door.
4. Lock one end of the handle into position by
tightening the set screw in the handle cap with the
allen wrench provided. DO NOT over-tighten.
.HHSVXSSRUWLQJWKHKDQGOHDV\RXORFNWKHRWKHU
end of the handle into position by tightening the set
screw in the handle cap. DO NOT over-tighten.
Repeat these instructions for the second handle.
WARNING
TIP OVER HAZARD
These appliances are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death
or serious injury. Read and follow the entire
installation instructions for securing the appliance
with the anti-tip system.
Anti-Tip
Bracket
Screw
LOOSEN
set screw
set screw
fastener
handle cap
set screw
set screw
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...