Loading ...
Loading ...
Loading ...
6
Ductwork
Installation
5. Use 6” round steel pipe (not provided) to
connect the plastic exhaust on the hood to the
ductwork above. Use duct tape to make all
joints secure and air tight.
Refer to Figure 4.
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND
LOCAL ELECTRICAL CODES. BEFORE
CONNECTING WIRES, SWITCH POWER OFF
AT SERVICE PANEL AND LOCK SERVICE
PANEL TO PREVENT POWER FROM BEING
SWITCHED ON ACCIDENTALLY.
-
If hood is operating normally, connect three
wires (black, white and green) to house wires
and cap with wire connectors.
-
Store wires in the wiring box.
Duct Cover Installation
NOTE: BE CAREFUL WHEN USING
ELECTRICAL SCREWDRIVER, DAMAGE TO
THE HOOD MAY OCCUR.
6. Using reference E from Table 1 and
measurements on pages 11-12, mark the
leveling point for duct cover bracket.
7. Secure the duct cover mounting bracket to the
wall with two screws (provided). Make sure
all screws are tightened Refer to Figure 5.
NOTE: Inner duct cover will cover the duct
cover bracket.
8. Slide the entire duct cover onto the hood.
Refer to Figure 6.
Figure 4
Figure 5
Figure 6
Wiring to Power Supply
Loading ...
Loading ...
Loading ...