Loading ...
Loading ...
Loading ...
Changing Cooktop and
Oven Lights (somemodels)
Thermostat /
Screw--€_
h
FUuorescent
Light
©
GUass
Frame
Be sure the oven is unplugged and all parts are COOL before
replacing the oven light. Weara leather-faced glove for protection against possible
broken glass.
To Change the Cooktop Light (some models)
Usethe rocker switch located on the top left side of the control panel to turn the
cooktop light on or off.
1. Turn power off at the main source or unplug the range.
2. Removecontrol buttons.
3. Remove screws from backguard frame trim, two from each side, and lift off.
Remove the glass panel.
4. Remove bulb by sliding your fingers over the bulb at each end and rotating the
top of the bulb 1/4turn away from you. Replacethe bulb with one of the same
length and wattage.
5. A defective starter can be removed byturning it counter-clockwise 1/4 turn.
6. Replace the glass panel and frame trim on backguard.
7. Replace screws and control buttons.
To Change the Oven Light
Usethe rocker switch located on the top left sideof the control panel to turn the oven
light on or off.
1. Turn electrical power off at the main source or unplug the oven.
2. Presswire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield in socket and snap wire holder into place.
5. Turn power back on again at the main source (or plug the oven back in).
6. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Owner's Guide.
Adjusting Oven
Temperature
(Easyand continuous cleaning models
only, Self-cleaning model refer to the
electronic timer guide)
Figure 1: Back of Control Knob
L Note position of pointer
prior to adjustment
The temperature in the oven hasbeen set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven istoo hot or
too cool, the temperature inthe oven canbe adjusted. Before adjusting, test a recipe
by using a higher or lower temperature than the recommended temperature. The
baking results should help you to decide how much of an adjustment is needed.
To Adjust Oven Temperature:
1. Check to be sure the Temperature Control knob is in the OFFposition.
2. Pull Temperature control knob straight off the shaft.
3. Loosen, but do not remove, the two screws at the back of the knob (Figure 1).
Note: If knob does not have 2 screws, it is not adjustable. There isa series of
small indicator grooves. Oneof these grooves ispositioned next to atiny pointer.
Note the position of the pointer.
4. To increase the temperature, move the pointer in a clockwise direction. To
decrease the temperature, move the pointer in a counterclockwise direction.
The temperature can be adjusted in increments of IO°F.
5. When the desired adjustment is reached, tighten both screws.
6. To replace the knob, line up the flat sides of both the knob and the shaft. Push
the knob into place. DO NOT force the Temperature Control knob onto the shaft
or you may damage the back of the knob.
Note: Once an adjustment is made, the OFFposition will vary from the reference
mark on the backguard depending on the amount of adjustment.
17
Loading ...
Loading ...
Loading ...