Loading ...
Loading ...
Loading ...
Section 2 - OPERATING INSTRUCTIONS
2.2.2. PROPELLING MOWER
(Self Propelled Models)
1. Move ground speed control to the desired
speed position. See Figure 2.4.
2. Move wheel drive control against handle to
engage wheel drive and propel mower forward.
Forward speed can be adjusted while the mower is
moving by changing position of the ground speed
control. See Figure 2.4.
MOVE CONTROL
MOVE GROUND
AGAINST HANDLE
TO ENGAGE (FAST) SPEED CONTROL
WHEEL DRIVE SIXTH SPEED TO DESIRED
POSITION POSITION 7
/
/
WHEEL DRIVE
CONTROL
BLADE
CONTROL
FIRST SPEED
POSITION _-J_
FIGURE 2.4
2.3 STOPPING
Stop engine and blade by releasing the blade
control. Stop forward motion of mower by releasing
the wheel drive control.
2.4 HANDLE HEIGHT ADJUSTMENT
The height of the mower handle can be adjusted
as follows:
1. Loosen the nuts on each lower handle as
shown in Figure 2.5.
HIGHER
HANDLE
LOWER
I NUTS ON EACH
/ "
7/
FIGURE 2.5
2. Move upper mower handle up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
. WARNING
ei°_n_!i°_ _n1°rm°awd_rusbtli_;ecbutYirglehsiiggtth°:I
2.5 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and
move to desired cutting height. See Figure 2.6.
LOWEST CUTTING
I' I HEIGHT
t
iii:
HIGHEST
........" I-_ HEIGHT
FIGURE 2.6
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.7.
POSITIONS
FIGURE 2.7
Loading ...
Loading ...
Loading ...