Loading ...
Loading ...
Loading ...
BEFORE CALLING FOR SERVICE (continued)
Error code: tel or Temperature sensor failure. Turn off the dryer and call for service.
rE2
Display shows error Power cord is connected White (N) and red (L2) wires on power cord. Check power
code: PS (electric incorrectly, cord connections for neutral connection on the center
dryers only) terminal. 240 volts applied to the control, so it witl protect
itself.
Lint on clothes Lint filter not cleaned properly.
Excess static in
clothes after drying
Steam Features Not
Working
Laundry not sorted properly.
Excess static in clothes.
Dryer is overloaded.
Tissue, paper, etc., left in
pockets.
Fabric softener is not used or
used incorrectly.
Clothes dried too long (over
dried).
Drying synthetics, permanent
press, or synthetic blends.
Garments are still wrinkled at
the end of the STEAM REFRESH
cycle.
Water drips down the door
during steam cycles.
Odors are not completely
removed at the end of the
STEAM REFRESH cycle.
Remove the lint from the filter before every load. With the
lint removed, hold the filter up to a light to see if it is dirty
or clogged. If it looks dirty, follow the cleaning instructions.
With some loads that produce high amounts of lint, it may
be necessary to clean the filter during the cycle.
Some fabrics are lint producers (i.e., a fuzzy white cotton
towel) and should be dried separately from clothes that are
lint trappers (i.e., a pair of black linen pants).
Use a fabric softener to reduce static electricity. Be sure to
follow the manufacturer's instructions. Over drying a load of
laundry can cause a buildup of static electricity. Adjust settings
and use a shorter drying time, or use AUTO DRY cycles.
Divide extra large loads into smaller loads for drying.
Check pockets thoroughly before washing and drying clothes.
Use a fabric softener or the STATIC SHIELD option, if
equipped, to reduce static electricity. Be sure to follow the
manufacturer's instructions.
Over drying a load of laundry can cause a buildup of static
electricity. Adjust settings and use a shorter drying time, or
use AUTO DRY cycles. Select a LESS DRY setting on AUTO
DRY cycles, if necessary.
These fabrics are naturally more prone to static buildup. Try
using fabric softener, or use LESS DRY and/or shorter TIMED
DRY time settings.
Load only one to five garments (or a single butky item).
Do not mix fabric types. STEAM REFRESH is most effective
on 70/30 cotton/potyblends. Do not use on 100% cotton
items.
Steam is invisible. However, under some conditions, the
condensed fog may be seen, or condensation will form
on the inside of the door glass and may be seen dripping
down the glass.
Some odors are difficult to remove. Fabrics containing
certain difficult odors or very strong odors may not refresh
well and should be washed or dry cleaned instead.
34
Loading ...
Loading ...
Loading ...