Loading ...
Loading ...
Loading ...
• Retightenbelt keeper above transaxle
pulley,
• Place belt around clutchingidiom as
shown, making sure to route belt inside
of allbelt keepers.
• Chock to be sure belt is positionedcor-
rectlyand is on proper side of all belt
keepers.
• Reinstall mower.
IMPORTANT: Chock brake adjustment.
Tractor V-Belt Drive Schematic
Viewed from L.H. Side ofTractor
Belt Transaxle
Belt Keepers
I Belt Fan
(_j._r- En._ine Keeper Idler
l
TO ADJUST MOTION CONTROL LEVER
The motion control lever has been preset
at the factory and adjustment should not
be nocessary.
If for any reason the motion control lever
will not hold its position while at a selected
speed, it may be adjusted at the friction
pack Iocatedon the right side of chassis.
Park tractor on level surface. Stop trac-
tor by turning ignition key to "OFF" posi-
tion and engage parking brake.
• Place motion control lever in neutral (N)
position.
i hile holding Iocknut, loosen jam nut
Tighten Iocknut 114 turn.
While holding iocknut, tighten jam nut
securely.
NOTE:- If for any reason the effort to
move the motion control lever becomes
too excessive, reverse the above adjust-
ment procedure by loosening Iocknut 1/4
turn.
Road test tractor after adjustment and
repeat procedure if necessary.
TRANSMISSION REMOVAUREPLACE-
MENT
Should your transmission require removal
for service or replacement, it should be
purged after reinstallationand before
operating the tractor. See "PURGE
TRANSMISSION" in the Operation section
of this manual.
TO ADJUST STEERING WHEEL ALIGN-
MENT
Ifsteeringwheel crossbars are not hori-
zontal (left to right) when wheels are posi-
tioned straight forward, remove steenng
wheel and reassemble per instructionsin
the Assembly section of this manual.
FRONT WHEEL TOE-IN ADJUSTMENT
Front wheel toe-in is requiredfor proper
steering operation. Tee-in was set at the
factory and adjustment should not be nec-
essary. If parts in the front axle or steering
mechanism have bean replaced ordam-
aged, check toe-in and adjust ifnecessary.
TO CHECK TOE-IN
Positionfront wheels straight ahead.
Measure distance betweenwheels at
front and rear oftires (dimensions =A"
and "B._.).
• Front dimension •A" shouldbe 1/8" to
1/4" less than rear dimension "S".
TO ADJUST TOE-IN
• Loosen jam nuts at adjustment sleeves
on tie rod.
• Adjust tie red until dimension =A" is 1/8"
to 1/4" less than dimension "B'.
• Tighten jam nuts securely.
FRONT WHEEL CAMBER
The front wheel camber is not adjustable
on your tractor, If damage has occurred to
affect the front wheel camber, contact your
nearest authorized service center/depart-
ment.
ustment
Sleeves
_e Rod
Jam Nu_
27
Loading ...
Loading ...
Loading ...