Loading ...
Loading ...
Loading ...
4
4
3
Control Panel and Features
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
Knob does not advance during the progress of the cycle –
see cycle status lights for each stage of the process.
See “Cycle Guide” for detailed descriptions of cycles.
Select the cycle most suitable for your load. Delicates
will add a low amount of water for smaller loads and Heavy
Duty will add the most amount of water for large or bulky
loads. Items need to move freely. Tightly packing can lead
to poor cleaning performance and may increase wrinkling
and tangling.
The washer is factory set for multiple progressive spray
rinses. Removing the J-4 Jumper on the Coinslide Interface
Control inside the console will change the rinse setting to a
bath-type rinse, which should be used when installing the
optional Fabric Softener Dispenser.
WASH TEMP
Wash Temp senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment label instructions, use the warmest wash
water safe for your fabric.
• Warm and hot water may be cooler than your previous
washer.
• Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
1
2
3
START BUTTON
Press to start the selected cycle. Press and hold
for 3 seconds to pause the cycle and unlock the lid.
Press and hold for 10 seconds to cancel a cycle.
NOTE: If the wash basket is spinning, it may take several
minutes to unlock the lid.
CYCLE STATUS LIGHTS INDICATOR
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
SENSING LOAD
When the START button is pressed, the washer will ll to
the selected cycle water level. If the lid is closed when the
washer is done lling, the lid will lock and the washer will
begin operation.
If the lid is open when the water stops entering the
washer, the cycle will not begin until the lid has been
closed and the START button is pressed. If the cycle has
not been started within 10 minutes of the water lling the
washer, the washer will pump out the water.
NOTE: Avoid opening lid during sensing phase at
beginning of cycle. The sensing process will stop and
automatically set a heavy load when the washer is
restarted. The SENSING LOAD light may also come on
during the Soak and Wash portions of the cycle. This
is normal. To restart the washer after the lid has been
opened, close the lid and press START.
SOAK/WASH
You will hear the agi-peller moving the load. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected cycle
and sensed load size.
4
Not all features and options are available on all models.
Appearance may vary.
2
1
Enables Progressive
Rinses (jumper loaded)
All Bath Rinses & Added
Wash Water (jumper
removed)
Coin Slide Interface Module
Loading ...
Loading ...
Loading ...