Loading ...
Loading ...
Loading ...
Battery
cable
connection
(electric
start
only)
Your
generator
is
not
factory
-equipped
with
battery.
Check
local
battery
dealers
to
get
the
correct
battery
for
your
generator
according
to
below
specification.
# Item Description
1 Rated
Capacity 14Ah
2 Rated Voltage 12V
3 Working Temperature
-10£
-50
£
4
Maximum
peak
current
200A(Time< 5 Seconds),
at
50£ temperature
120A Continuous Time< 60S)
5
Maximum
peak
current
150A(Time< 5 Seconds),
at-10£ temperature
120A Continuous Time< 60S)
6
Internal resistance
< 30m!!
ffllen
full charged
7
Internal resistance ffllen more poller lack cause bigger i
poller lack nternal resistance
To
connect the battery, you will need
to
connect the battery
cables.
(see
below figure for connection details):
1.
Cut off cable ties securing battery cables and remove red
covers from battery terminals.
2.
First, connect the red cable
to
the positive
(+)
battery terminal
with the bolt and nut.
3.
Make sure connections are secure and slide rubber boot over
the positive
(+)
battery terminal and connection hardware.
4.
Connect the black cable
to
the negative
(-)
battery terminal
with the bolt and nut supplied and slide rubber boot over the
negative
(-)
battery terminal and connection hardware.
5.
Make sure all connections are secure.
Negative(-) terminal (black)
-
Emission
Information
The Environmental Protection Agency (and California Air Resource
Board for generators certified
to
CA standards) requires that
this generator comply with exhaust and evaporative emission
standards. Locate the emissions compliance decal on the engine
to
determine what standards the generator meets, and
to
determine
which warranty applies. This generator
is
certified
to
operate on
gasoline. The emission control system includes the following
components (if equipped):
• Air Induction System
- Intake
Pipe/
Manifold
- Air Cleaner
• Fuel System
- Carburetor
- Fuel
Tank/
Cap
- Fuel Lines
- Evaporative Vent Lines
- Carbon Canister
• Ignition System
- Spark Plug
- Ignition Module
• Exhaust System
- Exhaust Manifold
- Muffler
- Pulsed Air Valve
- Catalyst
KNOW
THE
GENERATOR
Read the Owner's Manual and Safety Rules before operating
this generator.
Compare the generator
to
the following figure
to
become
familiarized with the locations
of
various controls and adjustments.
Save this manual for future reference.
1. 120V AC, 20 Amp Duplex Receptacle
(5-20R)-
Supplies
electrical power for the operation for electrical lighting, appliances,
tools and motor loads and
is
circuit breaker protected against
electrical overload.
2. 120V AC, 30 Amp Twist Lock Receptacle
(L5-30R)-
Supplies
electrical power for the operation electrical lighting, appliances and
motor loads and
is
circuit breaker protected against electrical
overload.
3. 120V AC, 30 Amp Receptacle (TT-30R,
RV)
- Supplies
electrical power for the operation electrical lighting, appliances and
motor loads and
is
circuit breaker protected against electrical
overload.
4.
120/240V AC, 30 Amp Twist Lock Receptacle
(L
14-30R) -
Supplies electrical power
to
the operation of electrical lighting,
appliances, tool and motor loads and
is
circuit breaker protected
against electrical overload.
5. 120/240V AC, 50 Amp Receptacle (L 14-50R) - Supplies
electrical power for the operation electrical lighting, appliances and
motor loads and
is
circuit breaker protected against electrical
overload.
6. Circuit Breakers (AC) - Protects the generator and receptacle
against electrical overload.
- SPG3640,SPG3645,SPG5568,SPG7593E,SPG831
OE:
120V
Duplex (Each) - 20A
7. Ground Terminal - Used to connect the generator to an
approved earth ground.
8. Hour Meter - Tracks generator running hours for regular
maintenance and service.
9. Engine Control Switch - Controls the operation of the
engine/generator.
10. Main Breakers (AC) - Protects the generator from electrical
overload.
- SPG3640, SPG3645: Main - 29.9A
- SPG5568: Main -
24.1
A
- SPG7593E: Main - 31A
- SPG831
OE:
Main - 34.5A
11. Circuit Breakers (AC) - Protects the generator and
receptacle against electrical overload.
- SPG7593E: L5-30R - 30A
12. Circuit Breakers (AC) - Protects the generator and
receptacle against electrical overload.
- SPG831
OE:
L
14-SOR
- 25A
IL
14-30R - 25A
6-ENG
Loading ...
Loading ...
Loading ...