Loading ...
Loading ...
Loading ...
CONNECTIONS – PLUMBING
37
LEFT AND RIGHT HAND SIDE WATER CONNECTIONS
The cold and hot water supplies (49 series 080 to 400 models) and temperature
pressure relief valve (49 series 080 and 125 models) can be connected to either
side of a water heater. A kit is supplied with the water heater to plug off the
unused cold water and hot water fittings, and where applicable the unused
temperature pressure relief valve fitting.
The kit contains:
Models 080 and 125
Models 160 to 400
2 x ¾” brass plugs
2 x ¾” brass plugs
1 x ½” brass plug
3 x plastic caps
2 x plastic caps
3 x insulation rubber discs,
pre-fitted into plastic caps
2 x insulation rubber discs,
pre-fitted into plastic caps
Plugging Off Unused Connections
Apply approved sealing tape or compound to the thread of each plug.
Fit the ¾” plugs to the unused cold water fitting and unused hot water fitting.
Tighten the plugs using either a 12 mm A/F hex driver or a 3/8” square driver,
as appropriate.
Fit the ½” plug to the unused TPR valve fitting (080 to 125 models). Tighten
the plug using either a 12 mm A/F hex driver or a 3/8” square driver, as
appropriate.
Fit a plastic cap with its insulation rubber disc over each plug.
080 to 160 models 250 to 400 models
SK7396
REV AD 02/13
INSULATION CAP & DISK ASSEMBLY
080-400 MODELS ELECTRIC
TPRV FITTING
080 & 125
MODELS ONLY
BRASS PLUG
INSULATION RUBBER
PLASTIC CAP
SK7659
REV AD 3/15
INSULATION CAP & DISK ASSEMBLY
250-400 MODELS ELECTRIC
BRASS PLUG
INSULATION RUBBER
PLASTIC CAP
Loading ...
Loading ...
Loading ...