Loading ...
Loading ...
Loading ...
9
DRAINING THE CONDENSATE
The moisture from the laundry is extracted in the
condenser unit and accumulated in the condensate
tank. Condensate tank has to be emptied regularly
(see chapter "CLEANING AND MAINTENANCE" in
the instructions for use.).
Interruption of the drying cycle due to full
condensate tank can be avoided by running the
condensate discharge hose found at the back of the
appliance directly into a drain.
A
Remove the small short hose from the attachment
(A).
max 1000 mm
max 39.4"
max 300 mm
max 300 mm
max 11.8"
max 11.8"
B
C
D
Connect the supplied drain hose to the same
attachment (A). The supplied drain hose has a
length of 78 3/4" (2000 mm).
Run the condensate drain hose into a drain. Tie the
hose onto a tap (B) so that it cannot slip during use.
The drain hose can also be fed into the washbasin
siphon (C) or directly into the fl oor drain (D).
Then, the water is pumped directly into a washbasin,
a siphon, or a fl oor drain.
Do not pull the drain hose, and make sure it is
not under tension, clamped, or bent.
If you decide to run the condensate drain hose
into a drain, siphon, or washbasin, make sure the
hose is securely fastened. This will prevent any
water spillage which could result in unexpected
damage.
Always use hoses that are supplied with the
appliance.
If the dryer is connected to an air exhaust
system already used for another appliance, a non-
return valve must be installed. Return fl ow into the
dryer could damage the appliance and the non-
return valve prevents such fl ow.
Loading ...
Loading ...
Loading ...