Loading ...
Loading ...
Loading ...
FEATURES (CONTINUED)
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted door control,
remote control, wireless keyless entry or myQ
®
accessory.
When the door is closed and the garage door opener is activated the door will
open. If the door senses an obstruction or is interrupted while opening the door
will stop. When the door is in any position other than closed and the garage door
opener is activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction
interrupts the sensor beam the garage door opener lights will blink 10 times.
However, you can close the door if you hold the button on the door control or
keyless entry until the door is fully closed. The safety reversing sensors do no
effect the opening cycle.
The safety reversing sensor must be connected and aligned correctly before the
garage door opener will move in the down direction.
DOOR CONTROL
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until
the garage door opener activates (it may take up to 3 presses). Test the door control
by pressing the push bar, each press of the push bar will activate the garage door
opener.
USING THE DOOR CONTROL
LOCK
Button
LEARN
Button
LIGHT
Button
NOTE: If the command LED is
continuously blinking, the Lock
feature needs to be deactivated.
Command LED
Push Bar
PUSH BAR
Press the push bar to open or close the door.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from
remote controls while still allowing activation from the door control and keyless
entry. This feature is useful for added peace of mind when the home is empty (i.e.
vacation).
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash
as long as the lock feature is activated and your hand held remote control will not
operate your door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED
will stop flashing and normal operation will resume.
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or myQ
®
accessories
can be programmed to the garage door opener by pressing the Learn button on
the Multi-Function Control Panel.
LIGHT
Press the LIGHT button to turn the garage door opener lights on or off. When the
lights are turned on they will stay on until the LIGHT button is pressed again, or
until the garage door opener is activated. Once the garage door opener is
activated the lights will turn off after the specified period of time (the factory
setting is 4-1/2 minutes). The LIGHT button will not control the lights when the
door is in motion.
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The
time interval is indicated by the number of flashes.
NUMBER OF TIMES GARAGE DOOR
OPENER LIGHTS FLASH
TIME THE GARAGE DOOR OPENER LIGHT
STAYS ON
1 1 ½ Minutes
2 2 ½ Minutes
3 3 ½ Minutes
4 4 ½ Minutes
To cycle through the time intervals repeat the step above.
LIGHT FEATURE
This feature will turn on the garage door opener lights when the safety reversing
sensors have been broken.
Deactivate:
Press and hold the LIGHT button until the garage door opener lights turn on, then
off again.*
Activate:
Start with the garage door opener lights on. Press and hold the LIGHT button until
the garage door opener lights turn off, then on again.*
* Approximately 10 seconds
34
Loading ...
Loading ...
Loading ...