Loading ...
Loading ...
Loading ...
ENGINEOIL
Drain oil (with engine warm) and replace with
clean engine oil. (See "ENGINE" inthe
Maintenance section of this manual).
CYLINDER
• Remove spark plug.
• Pour one ounce (29 ml) of oilthrough spark
plug hole into cylinder.
• Pullstarter handle slowly a few times to
distribute oil.
• Replace with new spark plug.
OTHER
• Do not store gasoline from one season to
another.
TROUBLESHOOTINGCHART
CAUSEPROBLEM
Doesn=stad
Loss of power
Poor cut - uneven
1. Dirtyair filter.
2. Out offuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken blade
adapter.
8. Control bar in released
pos .
9. Control bar defective.
,
.
3.
4.
5.
6.
Rear of lawn mower housing
or cutting blade dragging
in heavy grass.
Cutting too much grass.
Dirtyair filter.
Buildupof grass, leaves,
and trash under mower.
Too much oil in engine.
Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
17
• Replace your gasoline can if your can
startsto rust. Rust and/or dirtin your
gasoline will cause problems.
• Ifpossible, store your unitindoors and
cover itto give protectionfrom dust and dirt.
• Cover your unitwith a suitable protective
cover that does not retain moisture. Do
not use plastic. Plasticcannot breathe
which allows condensation to form and will
cause your unitto rust.
IMPORTANT: Never cover mower while
engine and exhaust areas are stillwarm.
ACAUTION: Never store the lawn
mower with gasoline in the tank inside a
building where fumes may reach an open
flame or spark. Allow the engine to cool
before storing in any enclosure.
CORRECTION
1. Clean/replace air filter.
2. Fill fuel tank.
3. Drain tank and refill with
fresh clean fuel.
4. Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5. Connect wire to plug.
6.
7.
8.
9.
1.
Replace spark plug.
T'_hten blade bolt or
replace blade adapter.
Depress controlbar to
handle.
Replace control bar.
Set to "Higher Cut"
position.
2. Set to "Higher Cut"
po_on.
3. Clean/replace air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
1. Replace blade. "l-K:jhten
blade bolt.
2. Set all wheels at same
height
3. Clean underside of
mower housing.
Loading ...
Loading ...
Loading ...