Craftsman 917271631 lawn tractor

User Manual - Page 19

For 917271631.

PDF File Manual, 60 pages, Download pdf file

Loading ...
Loading ...
Loading ...
BATTERY
Your tractor has a battery charging systern
which is sufficient for normal use° How-
ever; periodic charging of the battery with
an automotive charger will extend its life.
. Keep battery and terminals clean_
o Keep battery bolts tight°
. Keep small vent holes open.
o Recharge at 6-t0 amperes for I hour,,
NOTE: The original equipment battery on
your tractor is maintenance freer Do not
attempt to open or remove caps or covers.
Adding or checking level of electrolyte is
not necessary.,
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the batter,/and
terminals can cause the battery to "leak"
power.
Io Open battery box door,
2. Disconnect BLACK battery cable first
then RED battery cable and remove
batter/from tractor.
3, Rinse the battery with plain water and
dry.
4. Clean terminals and battery cable
ends with wire brush until bright.
5, Coat terminals with grease or petro-
leum jelly,
6. Reinstall batter/(See "REPLACING
BATTERY" in the SERVICE AND
ADJUSTMENTS section of this
manual).
V-BELTS
Check V-belts for deterioration and wear
after 100 hours of operation and replace
if necessary° The belts are not adjustable.
Replace belts if they begin to slip from
wear,,
TRANSAXLE COOLING
Keep transaxte free from build-up of dirt
and chaff which can restrict cooling.
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification SF - SJ. Se-
lect the oil's SAE viscosity grade accord-
ing to your expected operating tempera-
ture.
.................. SAEV,SCOSf_G'RADES
c _o ._0 -to o _o _o _o 4o
TEMPERATURE RANGE ANTIOIPATEO BEFORE NF.,XTOI,,L,,CHANGE
NOTE: Altllough multi-viscosity oils
(5W30, t0W30 etco) improve starting in
cold weather, these multi-viscosity oils
will result in increased oil consumption
when used above 32°R Check your en-
gine oil level more frequently to avoid
possible engine damage from running
low on oil.
Change the oil after every 25 hours of op*
eration or at least once a year if the trac-
tor is not used for 25 hours in one year,
Check the crankcase oil level before
starting the engine and after each eight
(8) hours of operation. Tighten oil fill cap/
dipstick securely each time you check the
oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change, All oil must meet API
service classification SF-SJ.
o Be sure tractor is on level surface.
, Oil will drain more freely when warm
o Catch oil in a suitable container°
1, Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine
when changing oil.
2. Remove yellow cap from end of drain
valve and install the drain tube onto
the fitting.
Oil Drain 'valve
Closed
and
Locked
Position
Drain Tube
Yellow
Cap
3. Unlock drain valve by pushing inward
slightly and turning counterclockwise.
4o To open, pull out on the drain valve.
5. After' oil has drained completely, close
and lock the drain valve by pushing
inward and turning clockwise until the
pin is in the locked position as shown.
6_ Remove the drain tube and replace
the cap onto to the end of the drain
valve,
7. Refill engine with oil through oil fill
dipstick tube_ Pour slowly. Do not
overfill. For approximate capacity see
"PRODUCT SPECIFICATIONS"
section of this manual.
!9
Loading ...
Loading ...
Loading ...