PAGE 1 98523C (Rev. SID - 1/13)
IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of
this unit with your actual water treatment needs. It is recommended that, before purchasing
a water treatment unit, you have your water supply tested to determine your actual water
treatment needs.
NOTICE: Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
CAUTION: Use on cold water line only. Do not allow installed filter to freeze.
NOTE: Performance will vary depending on local water conditions. While testing was
performed under standard laboratory conditions actual performance may vary.
NOTE: This system and installation shall comply with applicable state and local
regulations.
NOTE: Filter must be used with filter monitor for 3000 gallon rating.
Instructions For Installing Replacement Filters
1. Turn off water supply; dispense water to relieve pressure
2. Turn used filter counterclockwise 1/4 turn to remove from filter
head.
3. Remove cap from new filter and use to seal used filter.
4. Insert new filter into existing filter head and turn fully clockwise.
5. Turn on water supply and run a minimum of two gallons of
water through the filter to purge air and fine carbon particles
from filter. Also run water through glass filler (if provided)
LIMITED WARRANTY
The ELKAY WaterSentry
®
Plus is warranted to be free from defects in material and
workmanship for a period of one year from the date of installation. Warranty is limited to
repair or replacement of defective component.
Your Authorized Representative
Buyer
Seller
Capacity
Flow Rate
Temperature
3000 Gallons
1 Year Maximum
1.5 GPM
40-120° F (5-50° C)
RECOMMENDED USE CONDITIONS
Maximum Pressure 105 PSI (7.4 Kg/cm
2
)
Minimum Pressure 20 PSI (1.4 Kg/cm
2
)
Elkay
®
WaterSentry
®
Plus
Lead, Aesthetic Chlorine Taste & Odor & Particulate Class I Reduction
Filter Part No. 51300C FOR EWF3000 - WaterSentry
®
Plus
FOR COMMERCIAL USE ONLY
PERFORMANCE DATA SHEET
®
The Elkay
®
WaterSentry
®
Plus filter is certified by WQA to NSF/ANSI 42 and 53 for the
reduction of Aesthetic Chlorine, Taste and Odor, Particulate Class I, and Lead, as verified and
substantiated by test data.
Loading ...
