Loading ...
Loading ...
Loading ...
Ground Wire Screw
NOTE: Heater must be installed with the quartz tube horizontally level. For maximum
tube life, use a “carpenters level tool” nd the optimum level position for the heaters’
body.
Always maintain the below minimum clearances from
the heater body to any combust materials.
Wiring box on top of heater has a gasketed side access cover.
The wiring box inlet hole is sized
for a standard 1/2’ weather tight
conduit tting and has a locknut
located on the inside of the box
for fastening.
Connect power with exible
conduit or appropriate cord to
allow heater to be swiveled.
LEVEL HERE
Use a thin 11/32”
wrench to hold inside
nut. Nuts must be tight.
Connect the High Temperature
Stainless Terminal Loops on the
wire ends to the element studs
located on both ends of the
tube.
TYPICAL 115V
WIRING
FOR 115V SWITCH
TYPICAL 115V
WIRING
FOR 115V SWITCH
TYPICAL 115V
WIRING
FOR 115V SWITCH
“TOP” marked on rear of control
must be installed in an “UP”
position.
Snug to ceramic
Loading ...
Loading ...
Loading ...