Loading ...
Loading ...
Loading ...
16.PlaceRIPFENCE on table ...
CAREFULLY move it against blade so that it is parallel
to the blade, and just TOUCHES tips of saw teeth ...
tighten RIP FENCE LOCK KNOB HANDLE.
17. Insert folded paper between SPREADER and
FENCE... hold spreader flat against fence.., tighten
screws using 7/16 in. wrench, Now tighten Hex Hd.
Screws in Support.
18. To remove BLADE GUARD AND SPREADER, loosen
THUMBSCREW.,. DO NOT LOOSEN OTHER
SC R EWS.
7/'16 IN. WRENCH
FOLDED PAPER
MOUNTING THE MOTOR
NOTE: Motor is included with Model 113.298031 and
113.2981 51.
CHECK MOTOR ROTATION
1. The motor must rotate CLOCKWISE when viewed from
the 5/8 in. shaft.
2. MAKE 'SURE "KEY" IS REMOVED FROM SHAFT.
3. Place the motor on your we rkbench or on the floor.
4, Plug the cord into a properly grounded outlet (See
"Motor Specifications and Electrical Requirements"
Section) Notice the rotation of the shaft, If t is not
turning CLOCKWISE, REMOVE the plug from the
outlet, and change the rotation of the motor according
to the instructions furnished with the motor,
KEY
/
5/8 IN.
DIA. SHAFT
WARNING: FOR YOUR OWN SAFETY, MAKE SURE
PLUG IS NOT CONNECTED TO POWER SOURCE
OUTLET WHEN CHANGING MOTOR ROTATION.
5. From among the loose parts, find the following
hardware:
4 Carriage Bolts, 5/16 - 18 x 3/4 in. long
4 Hex, Nuts, 5/16- 18
(approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type
(approx. dia. of hole 5/16 in,)
6. Remove Blade Guard and Spreader.
7. Place motor on MOTOR BASE ... insert bolts through
holes in base ... then through the motor. Install
Iockwashers, and nuts.
B. Position motor so that edge of MOTOR FOOT and
MOTOR BASE are even ... slide motor all the way to
the RIGHT ... tighten the four nuts.
9, Loosen set screw in motor pulley using 6/32 in.
setscrew wrench. Slide pulley on shaft with HUB away
from motor. DO NOT TIGHTEN SETSCREW,
10. Install 3/16 in. square key (furnished with motor) in
grooves in pulley and motor shaft, DO NOT TIGHTEN
SETSCREW.
LOCKWASHER
5/16 IN.
NUT !
5/16-18
SHAF- _4.(_ ti /"
GUARD
\
(
THESE I"VVO CARRIAGE BOLT
EDGES EVEN 5/16-18 X 3/4 [_J.
KEY
/
/.
MOTOR BASE
MOTOR MOUNTING
BASE
PULLEY
16
Loading ...
Loading ...
Loading ...