Summit AIWD450FLTR Tabletop Ice & Water Dispenser

User’s Manual - Page 10

For AIWD450FLTR. Also, The document are for others Summit models: AIWD282, AIWD160, SCIWD282, AIWD450

PDF File Manual, 30 pages, Read Online | Download pdf file

AIWD450FLTR photo
Loading ...
Loading ...
Loading ...
10
Unpacking, etc.
After removing the packing materials, check the appearance of the dispenser for possible defects or
irregularities. If the product shows any irregularity in its appearance, contact the distributor.
All the packing materials (straps, box, Styrofoam, wood, etc.) should never be left within the reach of
children and should be disposed of according to local regulations.
For safety, the product should be installed and used with caution in accordance with the User’s
manual.
Incorrect installation or careless use of the product may damage or injure the environment, humans,
animals, and/or materials and property. The manufacturer does not bear any responsibility for the
aforesaid damage or injury.
The dispenser performs best at room temperature of 50~75°F and a supply of water at 50°F.
The dispenser should only be installed indoors and should NOT be installed near heat generators such as heaters,
stoves, or dishwashers
Product Installation
Where there is no heat source.
Install in a place where there is no heating device
such as a fireplace or a gas range and do not install in an
area outside the range of 10 ~ 38 /50 ~100
o
F.
Allow enough ventilation
For normal operation, install the dispenser at least 4
inches away from the back wall and 6 inches above the top
of the dispenser.
Never block the upper vents and do not place any
load on it.
Poor ventilation will decrease the unit’s ability to
make ice.
Install on a flat surface
Unstable installation may cause vibration and noise.
The recommended angle of installation is 1
o
A flat surface is recommended because there is a
possibility that the product will fall and cause injury when
the installation is made in a sloping place.
Installation should be indoors in a clean place
The drain hose should be installed at an angle so that drainage is good.
During installation and use, water leakage may occur due to various reasons. It must be used at a
place where drainage facilities are fully equipped
When installing the product indoors (places such as living room, store, the floor where damage
may occur due to leakage), please install natural drainage facilities and waterproof the floor.
Even when installing in the kitchen, a drain hole must be provided, and a drain hose must be
connected.
The manufacturer shall not be held responsible for the spreading damage caused by insufficient
drainage facilities in case of the above-mentioned problems and problems due to water supply hose
deviation or breakage.
Loading ...
Loading ...
Loading ...