Loading ...
Loading ...
Loading ...
5
Setting Up Your Speakers
The YU2 powered speaker system is designed for either desktop or bookshelf mounting to
enhance your computer audio listening in a near-fi eld environment. However, the YU2 can also
be used as a stand-alone stereo speaker system mated with a multitude of audio sources.
In either setup, the space between the two speakers and the distance from the rear wall is
important. If the speakers are positioned too close or too far apart, stereo imaging will not be
fully developed.
The YU2 is designed to perform optimally positioned at least 20cm to 25cm from the rear
wall for best bass response. Regardless of the setup you choose, keep in mind that rooms
vary in shape, size, and furnishing; a certain amount of experimentation may be necessary to
determine the most suitable position that delivers the most satisfying sound performance.
Ensure that the ON/OFF Switch is in the OFF position.
Connect the two speakers together as shown below using the supplied speaker cable. Connect
the RED (+) and BLACK (−) terminals from the active speaker (left) to the corresponding
terminals on the passive speaker (right). If you wish to place your speakers farther apart than
the supplied cable will reach, we recommend that you purchase a heavier gauge of speaker
cable to minimize signal loss.
Follow the instructions on the ensuing pages to connect your audio sources to YU2. The
examples in the following pages are not meant to be exhaustive - just examples.
Connect the AC/DC power supply from YU2’s active speaker to your wall outlet. Turn YU2’s
Volume Control clockwise to the ON position, then adjust the volume.
ATTENTION
When connecting audio cables the ON/OFF Switch must be turned OFF. After connecting all cables, the unit can be
turned ON.
When the volume is high, this system can produce noise levels that could permanently damage your hearing.
YU2 is a self-powered speaker system. Do not connect the speaker terminals to the speaker outputs of a stereo
amplifi er. Damage may occur. Use only the power supply provided with the speakers.
í
Volume
+
OFF
í
*
*
*
Loading ...
Loading ...
Loading ...