Loading ...
Loading ...
Loading ...
OPERATING INSTRUCTIONS
Timer Function
To set the Auto-off timer:
• Ensure the unit is turned on
• Press the Timer button and the Timer Off
indicator light will illuminate
• Press the Up or Down buttons to select the
desired amount of hours before the unit turns off
To set the Auto-on timer:
• Ensure the unit is turned off
• Press the Timer button and the Timer On
indicator light will illuminate
• Press the Up or Down buttons to select the
desired amount of hours before the unit turns on
Notes:
• The Up and Down buttons will increase or
decrease the time in 0.5 hour increments up to
10 hours and then in 1 hour increments up to 24
hours
• The display will revert back to showing the
previous temperature setting if the unit does not
receive a signal within a 5 second period during
programming
• Turning the appliance on or off at any time
or adjusting the timer setting to 0.0 hours will
cancel the Auto-timer settings
Using Timer On and Timer Off Simultaneously
If there is a need for the appliance to turn on, run
for a set period of time and then turn off, the on
and off timers can be used at the same time by fi rst
setting one and then the other. Both indicator lights
will illuminate and the display will count down to
the appliance either turning off or on, whichever
function was set fi rst.
Note: The timer will not cycle the appliance on and
off indefi nitely. The on and off timers will function
one time and then the appliance will return to
regular functioning.
Follow Me Function
There is a temperature sensor built into the remote
control that will continuously collect the current
room temperature. Keep the remote control with
you and the appliance will automatically adjust the
set temperature based on the current temperature
where you are located to reach the most
comfortable condition and temperature.
Press the Follow Me button to activate the Follow
Me function. The remote will display the current
temperature at its location. The remote will send
a signal to the air conditioner every 3 minutes, so
long as you remain within range of the appliance.
The Follow Me light on the control panel of the
appliance will illuminate for 5 seconds every three
minutes to indicate that it has received a signal
from the remote. If the appliance does not receive a
signal from the remote during any 7 minute interval,
it will beep to indicate that the Follow Me mode has
ended.
The maximum distance for the Follow Me feature is
8 meters (26 feet). This feature is available in Cool
and Auto modes.
Sleep Function
The Sleep Function can be used to conserve energy
during sleeping hours.
When selected, the set temperature will increase
by 2 degrees over a 2 hours period. The appliance
will hold the new set temperature for 7 hours before
automatically returning to normal operation.
The Sleep Function can be canceled at any time by
pressing the Sleep Button.
Ionizer Function
The Ionizer Function is a form of air purifi cation that
negatively charges the air. Dust particles, pollen
and other particles in the air cannot pass through
the fi lter when they are negatively charged. This
ensures that the maximum amount of dust and dirt
are removed from the air. Additionally, the ionizer
function helps to remove unwanted odors from the
air.
8
Loading ...
Loading ...
Loading ...