Loading ...
Loading ...
Loading ...
10
6-C WALL MOUNT HIGH BACKGUARD WITH HIGH SHELF - REPLACE THE VENT TRIM
1
5
2
3
4
Remove the flat vent trim
1 If using the high backguard with high shelf, you must
install the angle trim (supplied) first.
First, remove the two screws at the back of the trim
as shown.
2 Carefully lift off the flat vent trim and also the pan
supports/griddle/grill frame etc.
IMPORTANT!
Be careful not to touch any exposed electrical
wiring or internals at this stage.
Install the angle vent trim
3 Paying particular attention to the metal tabs around
the opening of the range, carefully place the angle
trim down over the rear trim of the range.
4 The angle trim must fit properly over the spill guards
and hob edge.
5 Refit the two screws into the rear trim as shown.
Flat Vent Trim
Loading ...
Loading ...
Loading ...