Loading ...
Loading ...
Loading ...
Heat Controller Room Air Conditioner with R-410A Owner’s Manual
12
INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
#5 Sears or Carrier 51S Series
( 18 Deep)
1. Remove existing rear grille as shown on Page
6 of this manual and replace with provided
louvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
5
8
/
2. Install (2) tapered spacer blocks to the floor of
the sleeve as shown. This helps induce a
rearward slop on the unit.
3. Install as shown with the tapered end from
the back of the sleeve. This helps induce a
rearward slop on the unit.
4. Attach (1)1 x3/8 x25 long seal in the center
at the top of the sleeve. Remove the backing
paper and press into position.
5. Attach (2) 1 x3/8 x14 seals to the left and
right sides of the sleeve.
6. Cut (2) 1 x3/8 x25 long seals to 14 long
and attach it to the vertical sections of the rear
grille as shown.
7. Center unit and gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
11.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
12.Seal & Frame the unit as described on page 17.
13. If you have difficulty with mounting the grill to
the sleeve, follow the instructions for direct
mounting on Page 16.
1
/
2
5
4
4
4
4
4
3
8
3
8
11
#5 Sears of Carrier 51S Series
- 18-5/8” Deep
1. Remove existing rear grille as shown on Page 6 of this
manual and replace with provided louvered rear panel.
Install as shown here.
NOTE: you may need to drill holes in ange of existing
sleeve to match new rear grille.
2. Install (2) tapered spacer blocks to the oor of the
sleeve as shown. This helps induce a rearward slope
on the unit.
3. Install as shown with the tapered end from the back
of the sleeve. This helps induce a rearward slope on
the unit.
4. Attach (1) 1” x 3/8” x 25” long seal in the center at
the top of the sleeve. Remove the backing paper and
press into position.
5. Attach (2) 1” x 3/8” x 14” seals to the left and right
sides of the sleeve.
6. Cut (2) 1” x 3/8” x 25” long seals to 14” long and
attach it to the vertical sections of the rear grille as
shown.
7. Center unit and gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd screw
from front on left side of unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire
to the unit as shown in picture. Make sure that the
toothed washer is against the cabinet.
11. Slide the unit completely to the rear to ensure a good
seal, making sure the ground wire does not become
tangled.
12. Seal & Frame the unit as described on page 17.
13. If you have difculty with mounting the grill to the
sleeve, follow the instructions for direct mounting on
Page 16.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...