Loading ...
Loading ...
Loading ...
Lower Chamber Assembly
1. Check that the silicone plug has been installed and
locked onto the float securely.
2. Attach the float into the threaded float base
at the bottom of the lower chamber.
3. Place the assembled lower chamber on the water
dispenser.
Lid Assembly
4. Position the lid ring onto the upper chamber, making
sure both contours are aligned. Press fit together.
Caution: Do not push lid back forcefully.
Upper Chamber Assembly
5. Align the two ports and locking tabs at the bottom
of the pre-filter with the holes in the upper chamber
and snap it into place.
6. Twist the soaked filter onto the base of the
upper chamber. Securely tighten the filter to
the housing to make a tight seal for effective
filtration.
7. You can now place your assembled upper chamber
on top of the lower chamber.
Manual Filter Change Reminder
8. To use the manual filter change reminder, turn the
dial on the lid until the number in the green circle
coincides with the month that the filter is being
installed. The number that appears in the red circle
will be the month to replace your filter. Repeat above
step for every filter change.
Filling the Filtration System
CAUTION! Never use water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the filtration system.
CAUTION! Once the filtration system is placed on the
water dispenser it should fit level and secure. The float
mechanism that fits inside the water dispenser must
NEVER be obstructed and be allowed to operate freely!
1. Open the top cover.
2. Pour cold tap water into the upper chamber.
CAUTION – Hot water should not be used with the
GWF8/GWF3 Water Dispenser Filtration System
(Max. 85°F/29°C – Min. 32°F/0°C).
OPERATING INSTRUCTIONS
2.
4.
5.
1.
6.
8.
Loading ...
Loading ...
Loading ...