Loading ...
Loading ...
Loading ...
9
Operation Instructions (continued):
Cleaning and Maintenance:
The temperature of the cold water reservoir is monitored by a cold water control
located at the rear of the dispenser. By turning the thermostat set screw (Figure 20)
the temperature can be adjusted. Using a screwdriver, turn the dial clockwise between
“L” (lower setting for warmer water) and “H” (higher setting for colder water) until the
desired temperature is reached. If water is not being properly dispensed, there could
be possible ice build-up in the reservoir due to the thermostat being set too cold.
If this happens, slowly rotate the thermostat set screw counter-clockwise to a warmer
setting.
NOTE: The drip tray is NOT dishwasher safe.
To remove, pull the drip tray towards you. Drain and clean. The drip tray should be
emptied and cleaned regularly to remove spotting and mineral deposits.
Clean with a mild soap and water mixture. For tough deposits, add vinegar and let
soak until the deposits come loose. Then wash, rinse and dry thoroughly. Put the
grill back on the tray and install on the dispenser.
The outside of the dispenser can be wiped clean using a mild soap and water
mixture. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with
clean water and then dry surfaces.
Vacuum or sweep away the dust from the condenser coils (Figure 22) at the back of
the dispenser. Keeping the condenser coils clean improves cooling efficiency.
Adjusting the Cold Water Temperature (See Figure 20):
Cleaning the Drip Tray (See Figure 21) :
Cleaning the Outside of the Water Dispenser:
Dispensing Cold Water:
Figure 20
Figure 21
Figure 22
The cooling system on this unit is designed to activate automatically as soon as the power cord is connected.
1. When the blue LED light is “flashing” the cooling cycle is operational. When the blue LED is light is “on” the cooling cycle
(compressor) is off and the cold water has reached optimum temperature.
2. To dispense cold water, place cup/glass under dispensing spigot, push/hold the cold water dispensing button until the desired
amount of water is dispensed.
NOTE: This Water Dispenser left the factory with the cold water temperature control default setting positioned
for Energy Star compliance (Figure 20). This setting will deliver cold water temperatures between 8°C - 10°C
(46°F - 50°F).
NOTE: Any change to the cold water temperature control may effect Energy Star efficiency.
Condenser
Coils
L H
Thermostat
Set Screw
Loading ...
Loading ...
Loading ...