Loading ...
Loading ...
Loading ...
EN - 2
2.2 PRELIMINARY PROCEDURES
• Always wear suitable work attire, hard-wearing safety
footwear with non-slip soles and long trousers. Do
not operate the machine when barefoot or wearing
open sandals. Wear hearing protection devices.
• Never wear scarves, shirts, necklaces, bracelets,
• Tie your hair back if it is long.
• Wear protective gloves whenever your hands are at risk.
• Thoroughly inspect the entire work area and
remove anything that could be thrown by the
machine or damage the blade/rotating units
(stones, branches, iron wire, bones, etc.)
2.3 DURING OPERATION
• Do not use the machine in environments at risk
sparks which may ignite the dust or fumes.
• Do not expose the machine to rain or wet
environments. Water entering a power tool
will increase the risk of electric shock.
•
light in good visibility conditions.
• Avoid working with wet grass, in the rain and when
there is a risk of a thunderstorm, especially lightning.
• Pay careful attention to uneven ground
(hills, dips), slopes, hidden hazards and
obstacles that could limit visibility.
• Be very careful near ravines, ditches or embankments.
The machine could overturn if a wheel slides
over the edge or if the earth gives way.
• Always mow across a slope and never up and
down. Being very careful when changing direction,
wheels do not hit any obstacles (such as stones,
branches, roots, etc.) that may cause the machine
to slide sideways or make you lose control of it.
• The machine must not be used on slopes over
20°, regardless of the mowing direction.
• Do not incline the lawnmower during
without obstacles or high grass.
• Exercise caution when pulling the lawnmower
towards you or moving backwards. Look behind
you to make sure there are no obstacles.
• Never run, always walk.
• Do not allow the lawnmower to pull you along.
• Always keep hands and feet away from the blade,
when starting and when using the machine.
• Keep away from the discharge opening.
• Never operate the machine with damaged, missing
or incorrectly assembled guards (grass catcher,
side discharge guards, rear discharge guards).
• Never disengage, deactivate, remove or tamper
with the safety systems/micro switches installed.
If something breaks or an accident occurs during
mowing, turn o the motor immediately and move the
machine away to prevent further damage; if an
accident occurs with injuries or third parties are
injured, carry out the rst aid measures most suitable
for the situation immediately and contact the medical
authorities for any necessary health care. Carefully
remove any debris which could cause damage or injury
to persons or animals if ignored.
2.4 MAINTENANCE, STORAGE
Ensure regular maintenance and correct storage to
maintain machine safety and high performance levels.
• Never use the machine with worn or damaged parts.
Faulty or worn-out parts must always be replaced and
never repaired. Use original replacement parts only.
•
•
with debris inside a room.
• Make sure that machine movements do
The noise and vibration levels shown in these
instructions are the maximum levels for use of the
machine. The use of an unbalanced cutting blade,
the excessive speed of movement, or the absence of
maintenance have a signicant inuence on noise
emissions and vibrations. Consequently, it is necessary
to take preventive steps to eliminate possible damage
due to high levels of noise and stress from vibration.
Maintain the machine well, wear ear protection devices,
and take breaks whilst working.
2.5 BATTERY / BATTERY CHARGER
IMPORTANT The following safety instructions
are in addition to the safety requirements
provided in the specic battery and battery
charger manual delivered with this machine.
• Only use battery chargers recommended by the
battery charger may cause electric shock, overheating
•
your power tool. The use of other batteries
•
inserting the battery. Inserting a battery in a
•
2.6 ENVIRONMENTAL PROTECTION
• Comply with local regulations for the disposal of
packaging, deteriorated parts or any elements with
a strong environmental impact; this waste must
not be disposed of as normal waste, it must be
centres where the material will be recycled.
• Comply with local regulations for the
disposal of waste materials.
• When the machine is withdrawn from service,
do not dispose of it in the environment, but take
it to a waste disposal facility in accordance
with the local regulations in force.
Do not throw electrical equipment away with
domestic waste. According to the European
Directive 2012/19/UE on electrical and electronic
in compliance with national standards, old
Loading ...
Loading ...
Loading ...