Loading ...
Loading ...
Loading ...
Page 10
ASSEMBLY
2. Position the direction-of-rotation
selector to the left of the tool for forward
rotation, and press the trigger switch to
turn on the mode-indicator light.
3. Press the mode selector to change the
speed: press once for low, press twice
for medium, and press a third time for
high.
4. To make the Auto-stop function
available, press and hold the mode
selector for three seconds: the auto-
stop indicator will shine. When a bolt/
nut is sufficiently tightened, the tool
will automatically stop the impact
and rotation after approximately one
second.
5. To turn off the auto-stop function, press
and hold the mode selector for three
seconds again. The auto-stop indicator
is will turn off.
ELECTRIC BRAKE
The impact driver is equipped with an
electric brake. When the trigger switch
is released, the electric brake engages
automatically to quickly stop the rotation.
LED WORKLIGHT RING (FIG.5)
The LED worklight rings, located around
the shaft of the impact driver, will illuminate
when the trigger switch is depressed. This
provides additional light on the surface of the
workpiece for operation in lower-light areas.
The light will automatically turn off within 10
seconds after the trigger is released.
INSTALLING THE BELT CLIP
(FIG.6)
1. Remove the battery from the tool.
2. Align the rib of the belt clip with the hole
on the base of the driver.
3. Insert the screw and securely tighten
the screw with a screwdriver.
REMOVING THE BELT CLIP
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw
that attaches the belt clip to the driver.
3. Remove the screw and the belt clip.
FIG. 5
Belt Clip
FIG. 6
Loading ...
Loading ...
Loading ...