Loading ...
Loading ...
Loading ...
6
PY-2E10 Car Power Amplifier
www.insignia-products.com
Specifications
RMS power @13.8VDC
Power @ 4 Ohms............................... 120W × 2
Power @ 2 Ohms............................... 200W × 2
Bridged power @ 4 Ohms ................. 360W × 2
Minimum speaker impedance .............. 2 Ohms
THD distortion ....................................... 0.08%
IMD distortion........................................ 0.08%
Frequency response............................. 20 Hz to 20 KHz
Input sensitivity..................................... 200mV to 6V
Input impedance ................................... 15K
Signal-to-noise ratio ............................. 90dB
Channel separation............................... 50dB
Remote bass control ............................ 0dB to +12dB
Crossover network
Low pass filter .................................... 45 Hz to 300 Hz
Bass boost ......................................... 0dB to +12dB
High pass filter ................................... 45 Hz to 300 Hz
Fuse rating............................................. 20A × 2
Size L × W × H ....................................... 15.67 × 10.16 × 2.56 inches
................................................................ (398 × 258 × 65 mm)
Troubleshooting
Before removing your amplifier, locate the problem in the following
table. Always test the speakers and speaker wires before
troubleshooting the amplifier.
Symptom Solution
The amplifier
will not turn on.
• Make sure that the amplifier has a good
ground connection.
• Make sure that the power at the remote
DC terminal is at least 7VDC.
• Make sure that there is battery power at
the positive (+) terminal.
• Make sure that all fuses are good.
• Make sure that the indicator LED is not
red. If the indicator LED is red, turn off
the amplifier briefly, then turn it back on.
Insignia-PY-2E10-Car Amplifier.fm Page 6 Tuesday, May 3, 2005 2:19 PM
Loading ...
Loading ...
Loading ...