Patriot Lighting E9201BZ - Dualux Bronze LED Dual Head Motion Sensor Outdoor Security Flood Light

Installation and Operator - Page 6

For E9201BZ. Also, The document are for others Patriot Lighting models: E9201-2BZ, E9201-1WH

PDF File Manual, 7 pages, Read Online | Download pdf file

E9201BZ photo
Loading ...
Loading ...
Loading ...
Spare Parts List:
CARE AND MAINTENANCE
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature deterioration of the
finish. This is not a defect in the finish and will not be covered by the warranty.
The following parts are available for reorder if damaged or missing. Call our toll free at 1-800-887-6326.
Page 6 of 7
201015
Wire Connector
X3
Gasket
X1
AA
CCBB
DD EE
Decorative cover
X1
FF
Mounting Screw
X2
Mounting Strap
X1
Fixture Mounting Screw
X1
Assembly Kit
6323MM (1 SET) for 356-9428
6328MM (1 SET) for 356-9429
TROUBLE SHOOTING
Problem
The light will not come on.
The light comes on during the
day.
The light comes on for no
apparent reason.
The light switch is turned off.
Possible Cause Solution
The fuse is blown or the circuit
breaker is turned off.
Turn the light switch on.
Replace the fuse or turn the circuit
breaker on.
Recheck after dark.
Verify the wiring is correct.
Re-aim the motion sensor to cover
the desired area.
Increase the “SENS” setting.
Daylight turn-off (photocell) is in
effect.
The circuit wiring is incorrect (if this
is a new installation).
The motion sensor is aimed in the
wrong direction.
The outside air temperature is close
to the same as a person’s body heat.
The motion sensor may be installed in
a relatively dark location.
The light fixture is operating
normally under these circumstances
Set the “TIME” switch to the 30s,
1min,3min setting.
The “TIME” switch is in the “TEST”
position.
The motion sensor may be sensing
small animals or automobile traffic.
Decrease the “SENS” setting or
reposition the motion sensor.
Decrease the “SENS” setting.
Decrease the “SENS” setting.
Do not use a dimmer or timer to
control the light fixture. Replace the
dimmer or timer with a standard
on/off wall switch.
The “SENS” switch is set too high.
The outside temperature is much
warmer or cooler than a person’s body
heat (summer or winter).
The light fixture is wired through a
dimmer or timer.
Loading ...