Loading ...
Loading ...
Loading ...
OPERATING INSTRUCTIONS
MAINTAINING YOUR HEATER
WARNING! Before cleaning, turn the electrical power off at the electrical panel board (circuit breaker
or fuse box). Lock or tag the panel board door to prevent someone from accidentally turning the power
on while you are working on the heater. Failure to do so could result in serious electrical shock, burns,
or possible death.
1. The heater must be properly installed before it
is used.
2. DANGER: High temperatures may be gener-
ated under certain abnormal conditions. Do not
partially or fully cover or obstruct the front of this
heater.
3. If the heater over temperature limit trips more
than once per day, the heater must be replaced.
4. Clean heater at least every 24 months or as
required. See “Maintaining Your Heater” section.
5. Any other service not detailed in this Owner’s
Guide should be performed by an authorized ser-
vice representative.
Maintenance As Needed, or every 24 months minimum.
1. It is important that you verify power has been turned off and no
power is going to the heater before proceeding. Circuit breakers
are often not marked correctly and turning the wrong breaker off
could mean electricity is owing to the heater, even if the heater
does not appear to be working. If you are uncomfortable working
with electrical appliances, unable to follow these guidelines, or do
not have the necessary equipment, consult a qualied electrician.
2. Once you verify the power has been turned off correctly, pro-
ceed to the next step.
3. Remove cover.
4. Wash cover with hot soapy water and dry immediately.
5. Use a hair dryer, or vacuum on blow cycle, to blow debris
through the element (do not touch element).
6. Vacuum area without touching the element.
7. Replace cover and secure.
8. Turn thermostat to desired setting.
9. Turn power back on at the electrical panel board.
How to operate your heater
The room temperature is controlled by a line voltage thermostat located either on the wall, or on the heater. Once installation is com-
plete and power has been restored, if you have a mechanical thermostat, follow steps 1 through 3 below. If you have an electronic
thermostat, follow the instructions in the programming and operating guide included with your thermostat.
1. Turn the thermostat fully on.
2. When the room reaches your comfort level, turn the thermostat knob counterclockwise until the heater turns off. The heater will
automatically cycle around this preset temperature.
3. To reduce the room temperature, turn the knob counterclockwise. To increase the room temperature, turn the knob clockwise.
PLEASE NOTE: Upon initial start-up, the heater may emit a burning odor. This is not dangerous, and is due to a protective lubricant
used during the manufacturing process. It typically dissipates within several hours.
Page 6
Loading ...
Loading ...
Loading ...