Page 1 (cover) Page 2 (inside)
Page 3 (inside) Page 4 (back)
Black border shows
page size and should
not print
Black border shows
page size and should
print
11.0"
8.50"
360° Ceramic
Heater/Fan
Model No.
CZ360BK
USAGE:
HEATER OPERATION: Always operate the heater in the upright
position following all instructions and recommendations listed in this
manual. HEATER LOCATION: Place the heater in the area of the
room that is coldest. HEATER CONNECTION: Plug heater directly
into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in
outlet. A loose connection may cause overheating and damage to
the plug or heater. NOTE: To prevent overloading a circuit, do not
plug the heater into a circuit that is servicing other electrical needs.
POWER INDICATOR: When the MASTER POWER SWITCH (Fig. 1)
is turned on (I), the power indicator light will illuminate to tell you the
heater has power (Fig. 3).
TURNING HEATER ON: To start the heater, switch the MASTER
POWER SWITCH to the ON «I» position.
NOTE: The Power Indicator Light will illuminate once the Master
Power Switch is turned ON (Fig. 3). On the PUSH-BUTTON
CONTROL PANEL located on the front of the heater (Fig. 2), press
the On/Off button to the ON position and the On/Off indicator light
will illuminate (Fig. 3). Press the desired FAN ONLY, LOW HEAT or
HIGH HEAT push button control setting and the applicable setting
indicator light will illuminate. The heater will operate on the selected
setting continuously. Then rotate the Thermostat Control clockwise
to the MAX THERMOSTAT position
as described later in the
SETTING THERMOSTAT.
SETTING THERMOSTAT: Fig. 4. After heater has been
turned on and the room has reached the desired
temperature, slowly rotate the thermostat knob
counter-clockwise until the heater shuts off (you should hear
a faint “click”). By leaving the thermostat at this setting it will
automatically maintain this temperature. To lower the
temperature, rotate the knob further counter-clockwise
(towards the MIN position). To raise the temperature, rotate
the thermostat knob clockwise (towards the MAX position).
TURNING OFF: On the front PUSH-BUTTON CONTROL
PANEL (Fig.3) press the “On/Off” button from the “on”
position to the “off” position. The appliance will stop heating
and the “On/Off” indicator light will turn off.
NOTE: When the unit is powered off on the control panel,
the fan may continue to run for approximately 30 seconds
to cool off the ceramic elements and dispense any retained
heat. The unit will shut off automatically. Then switch the
“MASTER POWER SWITCH” on the lower back of the
heater to the Off «O» position before unplugging or
plugging in the heater (Fig.1). Heater should be unplugged
when not in use.
TO OPERATE FAN ONLY: On the PUSH-BUTTON
CONTROL PANEL located on the front of the heater (Fig. 2
and 3), press the On/Off Power button to the ON position
and the On/Off indicator light will illuminate (Fig. 3). Press
the FAN ONLY push button control setting and the Fan
Indicator Light will illuminate. The fan will operate on the
selected setting continuously.
PUSH-BUTTON CONTROL PANEL: This heater has three
settings: High Heat, Low Heat and a Fan Only setting. The
appropriate indicator light will illuminate above each setting
push-control button when pressed. Use the High Heat
setting (1500 watt) to raise the room temperature quickly.
When the desired temperature is reached use the Low Heat
setting (750 watt). It is usually sufficient to maintain a
comfortable temperature.
IMPORTANT SAFETY FEATURES:
The power indicator light, located near the control panel,
lights whenever the heater or fan is turned on. The heater is
equipped with an automatic overheat protection device
located inside the body of the heater. If the heater grille is
obstructed, or if the heater gets too hot for any reason, the
automatic overheat protection device will turn the heater off.
To reset the heater, simply turn power off and unplug the
heater for 10 minutes until it cools down and then you may
plug the heater in and restart. Be sure that the heater is on a
smooth level surface with no obstructions.
The heater is also equipped with a safety tip-over switch to
turn power off to the heater when the heater tips over. When
the unit is powered off on the control panel, the fan may
continue to run for approximately 30 seconds to cool off the
ceramic elements and dispense any retained heat. The unit
will shut off automatically. To resume heater functions simply
stand heater upright and follow the instructions "TURNING
HEATER ON" in this instruction manual.
PET OWNERS NOTE: The health of birds and some small
pets are extremely sensitive to the fumes given off during the
initial use of many appliances. Although these fumes are not
harmful to humans, it is recommended that this heater not be
used around birds and small pets during its initial use until
the manufacturing corrosion coatings burn off.
CARE AND MAINTENANCE:
WARNING: ALWAYS UNPLUG THE CORD BEFORE
MOVING OR SERVICING.
CLEANING: IMPORTANT! DO NOT IMMERSE HEATER/FAN
IN WATER! Clean the heater/fan grille with the vacuum brush
attachment on your vacuum cleaner. This will remove lint and
dirt from inside the heater/fan. DO NOT ATTEMPT TO TAKE
APART THE HEATER/FAN. DO NOT REMOVE THE
HEATER/FAN GRILLE. Clean the body of the heater/fan with
a soft cloth.
CAUTION: Do not use gasoline, benzene, paint thinner,
harsh cleaners, etc. as they will damage the heater/fan.
NEVER USE ALCOHOL OR SOLVENTS.
REPAIR:
DO NOT OPERATE THE HEATER WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE HEATER IF IT HAS
MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE: Keep original carton for storage of the heater.
Coil and tie the power cord to avoid damage during storage.
Save These Instructions
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is not
intended for use in a bathroom, laundry area, or similar
locations, or near sinks, washing machines, swimming pools or
other sources of water. Never locate heater where it may fall
into a bathtub or other water container. Do not use heater
outdoors. Do not use in damp environments such as flooded
basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot
when in use, to avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use
near combustible materials or flammable gases or sources of
heat. DO NOT USE in areas where gasoline, paint or
flammable materials are used or stored. Keep combustible
materials such as furniture, pillows, bedding, papers, clothes
and curtains at least 3 feet (0.9 m) from the front of the heater
and keep them away from the sides and rear. To prevent a
possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may
become blocked. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may cause an
electric shock, fire, or damage the heater.
WARNING:
ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
The supply cord has a polarized plug. As a safety feature this
plug will fit in a polarized outlet only one way. To prevent
electric shock, match wide blade of plug to wide slot, fully
insert plug. If the plug does not fit contact a qualified
electrician.
Do not operate any heater with a damaged cord or plug or after
heater malfunctions, has been dropped or damaged in any
manner. Do not operate heater with a broken heating element
or ceramic cone or any visual imperfections. For repairs
covered under warranty, see warranty statement. For all other
repairs contact Comfort Zone® Customer Service by telephone
or mail for information and assistance.
PET OWNERS NOTE:
The health of birds and some small pets are extremely sensitive
to the fumes given off during the initial use of many appliances.
Although these fumes are not harmful to humans, it is
recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing corrosion
coatings burn off.
INTENDED USE:
This product is intended for indoor residential and office use only, not
for industrial or other commercial application. Use only with electrical
wiring that is in good working order and that meets applicable codes
and ordinances. This heater must be plugged in to a 120V AC, 15 Amp.
(or larger) circuit. Do not plug anything additional into the same circuit.
If you have any questions whether your wiring is adequate, consult a
qualified electrician. Risk of fire, overheating, malfunction, property
damage, injury or even death may result if not adhered to.
Use your heater-fan only with a working smoke detector located in the
vicinity of your heater/fan.
While using your heater/fan, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we have
used the word “WARNING” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result in
injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
• Read all the instructions before using this heater/fan.
• This heater/fan is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Use provided handle when moving this
heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 feet (0.9 meters)
from the front of the heater-fan and keep them away from the sides
and rear.
• Do not use heater unattended. Use of extreme caution is necessary
when any heater is used by or near children, invalids, disabled
persons or pets.
• Do not operate the heater with a damaged power cord or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical
or mechanical adjustment or repair.
• Do not use heater outdoors.
• Use your heater only in dry environments. This heater is not intended
for use in a bathroom, laundry area, or similar locations, or near
sinks, washing machines, swimming pools or other sources of water.
Never locate heater where it may fall into a bathtub or other water
container. Do not use in damp environments such as flooded
basements.
• Do not place the heater on a small, unlevel, uneven or any surface
which might allow heater to tip or fall.
• For proper operation, heater should be placed on a smooth,
non-combustible surface. Do not place on rugs, carpet, vinyl flooring
or other plastic surfaces. Not for use outdoors or in wet areas.
• This heater is not designed as a primary heat source.
• Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or relocatable power tap (outlet/power strip).
Always unplug heater when not in use.
• Do not run power cord under carpeting. Do not cover cord with
throw rugs, runners or similar coverings. Arrange cord away from
traffic area where it will not be tripped over.
• To disconnect heater, turn controls off then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire or
damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces like a bed, where openings may
become blocked. Never cover grilles.
• A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or
injury to persons or property.
SAVE THESE INSTRUCTIONS
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser against defects in quality or workmanship for a period of one
year from the date of original purchase. If this unit fails because of a manufacturing defect within 30 days of
purchase, return the unit, with your receipt, to the retailer. After 30 days, but within the warranty period, if the unit
was purchased within the continental United States, return it, freight prepaid, to World and Main for repair or
replacement. If the unit was purchased outside the continental United States, return the unit to the place of
purchase. This warranty does not cover damage caused by misuse, abuse, overheating or alteration. Repairs made
by anyone other than World and Main are not covered in this warranty. World and Main will not be held liable for any
losses due to neglectful operation. All implied warranties, including the warranties of merchantability and of fitness
of purpose, if applicable, are hereby limited in duration to the period of one year from the date of original retail
purchase. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may
not apply to you. Incidental or consequential damages arising from a breach of either express or implied warranties
are hereby disclaimed and excluded. Some states do not allow the exclusion of limitation of incidental or
consequential damages, so this limitation or exclusion may not apply to you. Upon the expiration of this warranty all
such liability will terminate. No other warranties are expressed or implied.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. No
informal dispute settlement mechanisms are available. This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 030719
Fig. 3
INDICATOR
LIGHTS
CONTROL
BUTTONS
On/Off
Fan
Master Power Switch
Indicator Light
Low
Heat
High
Heat
On/Off
Fan
Only
Low
Heat
High
Heat
Features:
• Adjustable Thermostat
• Three Settings:
(I) High - 1500 Watts (5120 BTU)
(II) Low - 750 Watts
Fan Only
• Front Mounted Control Panel
• Power Indicator Light
• Safety Overheat Protection
• Safety Tip-Over Switch
• Convenient Stay Cool Body with Carry Handle
• 120V A.C., 60Hz, 12.5A
Fig. 4
Fig. 1
ON
OFF
MASTER POWER SWITCH
is located above the power
cord connection on the lower
back of the heater.
Adjustable thermostat
Push-button control panel
Indicator Lights
Fig. 2
During the heaters initial use, you may experience a slight odor
or smoking. This is the result of the heating element lubrication
“burning off”. This is normal and will go away after a few
minutes of use.
« I »
« O »
Pg. 1 Pg. 2
Pg. 3 Pg. 4
