Loading ...
Loading ...
Loading ...
14
6. Make sure that each skid shoe firmly touches the surface.
Then tighten the mounting nuts.
NOTICE
To prevent contact with the auger, make sure
that the mounting nuts are outside the auger housing.
Lubricate the Control Lever Linkage
Apply grease to the control lever linkage at the locations (A)
as shown in Figure 20.
20
Lubricate the Discharge Chute,
Deflector, and Wheel Axle
1. STOP the engine and remove the key.
2. Lubricate the discharge chute (A, Figure 21) with lithium
grease.
3. Lubricate the deflector (B) with clean engine oil.
4. Lubricate the wheel axles (C) with lithium grease.
Lubricate the Auger Assembly
1. STOP the engine and remove the key.
2. Lubricate the auger shaft assembly (A, Figure 22) with
grease at the grease fittings, (if equipped).
22
Lubricate the Hex Shaft and Gear
For friction drive systems only:
NOTICE
Do not let grease or oil touch the rubber friction
wheel or the disc drive plate. If grease or oil touches the
friction wheel, replace it. Do not clean it. If grease or oil
touches the disc drive plate, clean it thoroughly with an
alcohol based solvent.
1. STOP the engine. Remove the ignition key or push/pull
key.
2. Set the speed select lever to the first forward gear.
WARNING
Fuel and its vapors are extremely flammable, which could
cause burns or fire that result in death or serious injury.
• When performing maintenance that requires the unit to
be tipped, the fuel tank must be empty or fuel can leak
out and result in a fire or explosion.
21
19
Loading ...
Loading ...
Loading ...