Loading ...
Loading ...
Loading ...
W415-1867 / D / 02.25.20
EN
8
operating your appliance
1. Remove the right access panel from the side of the appliance.
2. Remove the front 2 screws from the inside edge (Fig. 2) and swing the
control door open.
3. Remove the 2 screws holding the receiver in place.
4. Remove the receiver and replace.
2.2.1 changing the batteries
• Ensure the gas and electrical power to the appliance is turned off.
• Appliance may be hot, do not service until the appliance has cooled.
!
WARNING
4 AA batteries must be installed into the receiver before the appliance can
operate by battery backup. The receiver is located in the bottom right corner
of the appliance (Fig. 1).
note:
Ensure the 3 position slider switch is in the "REMOTE" position (middle
position).
Fig. 1
Fig. 2
GDIG3 Illustrated
GDIG3 Illustrated
note:
If your opening is too small, you may need to pull the appliance out
slightly.
Receiver Removal
Battery Installation (GDI3E)
1. Remove battery holder by sliding it forward
from the bracket (Fig. 3).
2. Install 4 batteries.
3. Reinstall battery holder.
Fig. 3
Battery Holder
Bracket
Loading ...
Loading ...
Loading ...