Loading ...
Loading ...
Loading ...
7077-801D • September 17, 2019
(877) 477- 4768
4
CAUTION
After reading these instructions, if you have any doubt
about your ability to complete your installation in a
professional manner you should obtain the services
of an installer versed in all aspects as to the correct
and safe installation. Do not use temporary makeshift
compromises during installation.
BEFORE INSTALLATION OF YOUR APPLIANCE
1. Check with the building inspector’s oce for
compliance with local codes; a permit may be required.
2. Use 3” or 4” (76-102mm) diameter type “L” or
“PL” venting system. It can be vented vertically or
horizontally. Approved adaptors can be used to connect
the “L” or” PL” to approved wood stove venting
such as single wall or double wall venting previously
used to vent a wood burning appliance. INSTALL
VENT AT CLEARANCES SPECIFIED BY THE VENT
MANUFACTURE.
3. Always connect this unit to an approved chimney
system and NEVER vent to another room or inside
a building.
4. DO NOT INSTALL A FLUE DAMPER IN THE
EXHAUST VENTING SYSTEM OF THIS UNIT.
5. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE
SERVING ANOTHER APPLIANCE.
6. The connector pipe and chimney should be inspected
periodically and cleaned if necessary. Review
additional information located in the maintenance
section of this Owner’s Manual.
7. Remember the clearance distances when you place
furniture or other objects within the area. This includes
heat sensitive materials such as candles, seasonal
decorations or draperies. DO NOT STORE WOOD,
FLAMMABLE LIQUIDS OR OTHER COMBUSTIBLE
MATERIALS TOO CLOSE TO THE UNIT.
8. Be aware of the required clearances when locating
the unit. Refer to the label on the rear of the unit for
required clearances.
9. Contact your local municipal or provincial re authority
for information of how to handle a chimney re.
Have a clear understood plan to handle a chimney
re. In the event of a chimney re, CALL THE
FIRE DEPARTMENT.
10. Prior to burning the unit for the rst time make sure the
hardware kit has been removed from the rebox.
IMPORTANT
It is highly recommended that the pellet heater and
chimney be installed by a qualied installer. A qualied
installer is a person or entity who regularly installs solid
burning fuel products and chimneys in the course of their
ordinary business.
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room
as replace.
• Alert children and adults to hazards of high
temperatures.
• High temperatures may ignite clothing or other
ammable materials.
• Keep clothing, furniture, draperies and other
ammable materials away.
HOT SURFACES!
Glass and other surfaces are
hot during operation AND
cool down.
WARNING
If the information in these instructions is not
followed exactly, a re may result causing
property damage, personal injury, or death.
• Do not store or use gasoline or other ammable
vapors and liquids in the vicinity of this or any
other appliance.
• Do not over re - If heater or chimney connector
glows, you are over ring. Over ring will void
your warranty.
• Comply with all minimum clearances to combustibles
as specied. Failure to comply may cause house re.
WARNING
Fire Risk.
Tested and approved for wood pellets. Burning of
any over type of fuel will void your warranty.
WARNING
Loading ...
Loading ...
Loading ...