Loading ...
Loading ...
Loading ...
Page 13
MAINTENANCE
LUBRICATION
All of the bearings in this tool are lubricated
with a sufficient amount of high grade
lubricant for the life of the unit under normal
conditions. Therefore, no further lubrication
is required.
BEFORE EACH USE
1. Inspect the reciprocating saw, the on/off
switch and the accessories for damage.
2. Check for damaged, missing, or worn
parts.
3. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
4. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.
5. Detach the battery from the saw before
cleaning or performing any maintenance.
Using compressed air may be the most
effective cleaning method. Always wear
safety goggles when cleaning tools
using compressed air.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The saw does not work. The battery is depleted. Charge the battery.
The saw does not work and the tool
LED worklight flashes.
The tool is overheated. Cool down the tool.
The saw does not work and two
battery pack LED lights alternately
flash.
The battery is
overheated.
Cool down the battery.
The saw does not work and the battery
pack LED lights flash.
The battery is in
overloaded protection.
Load appropriate loading
force when cutting with
the saw.
Cutting is difficult. Saw blade is wore out. Replace the saw blade.
Loading ...
Loading ...