Loading ...
Loading ...
Loading ...
W415-2345 / C / 09.21.20
EN
26
fi nishing
4.3 log placement
A. Remove safety screen.
B. Remove cast top.
C. Remove glass door / cast front. See "glass
door / cast front installation / removal" in the
fi nishing section of this manual for more
information.
NOTE: It is not necessary to remove the cast front.
However, it will make log installation simpler.
D. Place the rear log, as shown,
onto the rear log support
brackets. Ensure the cutout
on the left underside of
the log fi ts over the pilot
assembly. Bend the bracket
on the right side to help
retain the rear log.
E. Place the hole in the
underside of log #2 onto the
locating screw on the left
side of the burner. The fi bre
burner is formed to cradle
the centre of the log.
F. Place the hole in the
underside of log #3 onto
the locating screw on the
right side of the burner. The
bottom branch of log #3 sits
in front of and against the
right end of log #2.
4.4 logo placement
LOGO
1.27cm
1.27cm
Remove the backing from the logo and position onto the
control door as shown.
LOG LOCATING SCREWS
BRACKET
G. Reinstall the glass door and cast front if removed.
H. Reinstall cast top and safety screen.
!
WARNING
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
Loading ...
Loading ...
Loading ...