Loading ...
Loading ...
Loading ...
6
ASSEMBLY INSTRUCTIONS
Hardware Used
AA
BB
Hardware Used
CC
1
2
1. Line up holes on the bracket of wheel assembly (O)
with the corresponding holes on base (M), then insert
M8 x 16 mm bolts (BB) through holes. Tighten with
M8 flange nuts (AA). Be sure the wheel assembly (O) is
parallel to the base (M).
Note: To improve stability, the preassembled bucket (N)
can be filled with sand (not included). Open the lid, fill
sand then close it.
2. Attach cylinder housing (H) loosely to base (M) with
M5 x 8 mm screws (CC). Tightening the bolts around the
base at the end.
3. Open the preassembled door (I) on cylinder housing
(H) and place post (J) through the hole on the top.
x 2
M8 x 16 mm Bolts
M8 Flange Nut
x 2
M5 x 8 mm Screw
x 4
H
M
N
M
AA
CC
BB
O
Fill sand
3
J
I
H
Loading ...
Loading ...
Loading ...