Loading ...
Loading ...
Loading ...
5
Design Features
Punch EQ
A Gyrator based Punch EQ that eliminates frequency
shift with boost. This works along with the crossover
switch on the amplifier.
Power/REM Terminals
The power and ground will accommodate 4 AWG,
while the remote will accommodate 12 AWG.(The
REM terminal is used to remotely turn-on and
turn-off the amplifier when +12V DC is applied.)
2/4 Channel Switch
Setting this switch to the 2CH. position, switches the in-
puts to a 2-channel mode, allowing connection to only
the front inputs with a 4-channel output. (PM400X4,
PM600X4, PM1000X5)
Crossover Switch
Selectable switch for High-Pass (HP) or
All Pass (AP) or Low-Pass (LP)
Variable Crossover
Is a built-in 12dB/octave Butterworth filter with
a crossover point variable from 50Hz to 250Hz.
illus.-1.1
Remote Punch Level Control - In/Out
Remotely control the output level of the amplifier. The
PLC-OUT is used to daisy-chain additional amplifiers
controlled by a single remote.
Infrasonic Filter
A fixed 28Hz 12dB/octave filter designed to prevent
frequencies below the audio range from being applied
to the subwoofer from the amplifier. Consequently
improving subwoofer performance and power han-
dling, particularly in vented enclosures. (PM500X1bd,
P10001BD, PM1000X5)
Remote Punch Level Switch
When activated, this allows the use of a optional remote
Punch Level Controller. (PM500X1bd, P10001BD,
PM1000X5)
INPUT CLIP
REAR SUBFRONT
RIGHT
LEFT
RIGHT
LEFT
B+
REM GND
REMOTE
PUNCH LEVEL
PLC-OUTPLC-IN
FRONT REAR
RIGHTLEFT
BRIDGED
RIGHTLEFT
BRIDGED
SUB
BA
SPEAKERS
INPUT
2CH. - 4CH.
Loading ...
Loading ...
Loading ...