Loading ...
Loading ...
Loading ...
EYE PROTECTION which conforms to ANSI specifications and
provides protection against flying particles both from the FRONT and
SIDE should ALWAYS be worn by the operator and others in the work
area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners
and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is
worn. Eye protection equipment must conform to the requirements
of the American National Standards Institute, ANSI Z87.1 and provide
both frontal and side protection.
NOTE: Non-side shielded spectacle
s and face shields alone do not
provide adequate protection.
Additional Safety Protection will be required in some environments.
For example, the working area may include exposure to noise level
which can lead to hearing damage. The employer and user must
ensure that any necessary hearing protection is provided and used
by the operator and others in the work area. Some environments will
require the use of head protection equipment. When required, the
employer and user must ensure that head protection conforming to
ANSI Z89.1 is used.
Page 8
TOOL OPERATION
OPERATION
I. READ AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.
II. REFER TO "PRODUCT SPECIFICATIONS” IN THIS MANUAL TO IDENTIFY THE
OPERATING SYSTEM ON YOUR TOOL.
The SEQUENTIAL TRIP is a contact tip that operates in conjunction with the trigger to drive a
fastener. To operate a sequential trip tool, first position the contact trip on the work surface
WITHOUT PULLING THE TRIGGER. Depress the contact tip and then pull the trigger to drive a
fastener. As long as the contact tip is contacting the work and is held depressed, the tool will
drive a fastener each time the trigger is depressed. If the contact tip is allowed to leave the
work surface, the sequence described above must be repeated to drive another fastener.
Loading ...
Loading ...
Loading ...