Loading ...
Loading ...
Loading ...
Page 11
WARNING:
Always wear safety
goggles or safety glasses with side shields
during power tool operations, or when
blowing dust. If the operation is dusty, also
wear a dust mask.
WARNING:
Do not at any time let
brake uids, gasoline, petroleum-based
products, penetrating oils, etc. come in
contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which
may result in serious personal injury.
MAINTENANCE
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety goggles when cleaning tools with
compressed air.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil,
grease, etc.
BEFORE EACH USE
1. Check for damaged, missing, or worn
parts.
2. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
3. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.
MAINTENANCE
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The blower does
not work.
The battery pack is
depleted.
Charge the battery pack.
The battery pack or
blower is too hot.
Turn off the blower and allow the blower
and battery pack to cool.
The temperature of the
battery pack is too low
while in low charge
1. Fully charge the battery pack again.
2. Keep the battery pack at room
temperature.
The air velocity
decreases
obviously.
The air inlet is blocked by
debris.
Remove the battery pack, clear the
debris.
Loading ...
Loading ...
Loading ...