Loading ...
Loading ...
Loading ...
16
HMX 6.5 LD / HMX 6.5 S-LD / HMX 8 S-LD LED direct wiring
FUSE
FUSE
FUSE
FUSE
RED
GREEN
BLUE
ORANGE (+ 12 V)
+ 12 Vdc
Switched +12V
GND
100 mA
100 mA
100 mA
2 Speakers
1 Speaker
N Speakers
100 mA
x N Speaker
COLOR RED GREEN BLUE
WHITE X X X
RED X
GREEN X
BLUE X
YELLOW X X
PURPLE X X
CYAN X X
LED CIRCUIT WIRING
- Voltage provided to the LED circuit must not exceed +12,5 Vdc referred to the system ground (GND).
- Voltage provided to the LED circuit should be switched by an activation circuit in order to turn-on the LED lighting only when
required and turn it off when vessel is not used or put into storage.
- Protect the ORANGE (+12V) wire with a 100mA fuse, then connect the ORANGE (+12V) wires from all the speakers together to the
main Switched +12 Vdc.
- Fuse the Switched +12 Vdc according to the total number of speakers connected
in parallel. We suggest for the fuse value to be as close
as possible to the standard
value corresponding to 100mA x N speakers rounded in excess. I.e. 6 speakers (3 pairs) in parallel requires
100mA x 6 = 600mA, for which the closest standard fuse value rounded in excess would be 630mA.
- Connect the R(Red), G(Green), B(Blue) wires from the speaker to the system ground (GND) referring to the below table according
to the color desired among the 7 available options.
COLLEGAMENTO DEL CIRCUITO LED
- La tensione fornita al LED non deve superare i 12,5 Vdc riferiti a massa (GND).
- La tensione fornita al LED dovrebbe essere controllata da un circuito di attivazione (+12V Switched) per accendere il LED solo
quando necessario e spegnerlo quando l’imbarcazione non viene utilizzata o rimessa.
- Proteggere con un fusibile da 100mA il cavo ORANGE (+12V), poi connettere insieme i cavi ORANGE (+12V) di tutti gli speaker al circuito
di attivazione (+12V Switched).
- Proteggere con un fusibile la tensione fornita dal circuito di attivazione (+12V Switched), il valore del fusibile deve essere calcolato
con la formula 100mA x N Speaker con il risultato approssimato al valore di fusibile standard più vicino. Esempio 6 speaker (3 coppie)
in parallelo richiedono 100mA x 6 = 600mA per il quale il valore standard più vicino è 630mA.
- Collegare i cavi R(Red), G(Green), B(Blue) dallo speaker al sistema di massa (GND) seguendo la tabella sotto in funzione del colore
desiderato tra i 7 disponibili.
Loading ...
Loading ...
Loading ...