Loading ...
Loading ...
Loading ...
Page 37
Section 13: Standard packages
To assist with the design and installation of a
system Dimplex have collated wiring and hydraulic
schematics for the following designs:
Package 1 and 2
Heating and Domestic hot water preparation is
done using the heat pump.
Buffer cylinder is supplied either in a combined
buffer/DHW cylinder (pack 1) or as a standalone
buffer (pack 2)
2 x two port valves are used to switch between
heating and DHW preparation.
Room temperature is time and temperature
controlled using the Horstmann wall mounted
thermostat. The thermostat will create a demand if
the temperature drops below 15C whilst the
system is off to prevent the base temperature
dropping too low.
DHW temperature is measured via NTC2 sensor
and time of production is set using the Heat pump
controller.
Includes a Taconova flow checker for efficient
setup and isolation valves with inbuilt filter to
ensure debris is removed.
Package 3
Package for space heating only. No hot
water cylinder is included.
Buffer cylinder is supplied to ensure
minimum water volume.
Room temperature is time and
temperature controlled using the
Horstmann wall mounted thermostat. The
thermostat will create a demand if the
temperature drops below 15C whilst the
system is off to prevent the base
temperature dropping too low.
Includes a Taconova flow checker for
efficient setup and isolation valves with
inbuilt filter to ensure debris is removed.
Loading ...
Loading ...
Loading ...