Loading ...
Franke care instructions
• Periodically clean the aerator filter;
• Install filter valves under the sink and periodically clean the filters;
• DO NOT USE DETERGENTS, SOLVENTS, CHEMICAL AGENTS, ABRASIVE
SPONGES, WIRE WOOL OR ALCOHOL, ETC., which would irreparably damage
the surface of the product and ruin its appearance, sheen and matt finishes;
• CLEAN WITH SOAPY WATER AND DRY WITH A SOFT CLOTH;
• Dry the product after use if the water is very hard or aggressive, as it may
leave deposits which would damage the surface;
• Do not install the tap when the water pressure exceeds 500 kpa (in this case
pressure limiting valves are required);
• Rinse the water pipes before installing the tap.
Technical Information
• Maximum hot temperature 80° (Recommended 65°)
• Maximum operating pressure 75 psi / 500 kpa
• Minimum operating pressure 7.25 psi / 50 kpa
• Ceramic cartridge
• Close the water.
• Place the tap in the hole and be sure the rubber washer (1) is between the tap and
the bench top.
• Introduce the triangle plastic base (2), washer (3), base (4) on the tap body tube.
• Screw the locking nut (5) on the tap body tube.
• Insert the flexible hose (6) into the faucet spout and be sure that the flexible hose (6)
can freely move under the bench.
• Insert the connector screw (9) into the flexible hose (6), screw the connector (7) into
the flexible hose (6) with the washer (8).
• Insert the connector (7) into facuet, tighten the connector screw (9) into the body.
• Install the weight (10) securely at the bottom of the flexible hose (6).
• Moderately screw the flexible hose (11) into the tap body.
• Connect the flexible hose (11) into the water supply pipes.
• Open the water.
Franke installation instructions
Rubber Washer
Plastic Fixing Set
Washer
Base
Locking Nut
Flexible Hose
Connector
Washer
Connector Screw
Weight
Flexible Hoses
1
2
3
4
5
6
7
8
9
10
11
Stainless Steel 304
Cartridge K-35A
Aerator Neoperl
Flex for Hand Shower
Hand Shower
Flexible Hose
(Aust. 203/26)