Loading ...
Loading ...
Loading ...
DISPLAY
REMOTE CONTROL SIGNAL RECEIVER
TEMPERATURE SETTING
• Usethisbuttonto automaticallycontrolthetemperature
of the room. The temperature can be set within a range of
60°F to 86°F by increments of I°F.
I _ ENERGY SAVER
V TEMP A _ [ [ . Thefanstopswhenthecompressorstopscooling.
J Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
ENERGY o
SAVER
[
MODE
FAN 0
COOL O
TIMER
ON/OFF
FAN
SPEED
H I/LO
_- DISPLAY COOL/FAN
I |. Everytimeyou pushthisbutton,itwill togglebetween
COOL and FAN.
|. You will usually use shut-off time while you sleep.
|. If unit is running, Timer sets number of hours until shut-off.
• For your seep ng comfort, once T mer s set, the Temperature
O i setting will raise 2°F after 30 min., and once again after another
30 min.
• Every time you push Timer button, it advances the Timer setting
as follows: ! Hour ) 2 Hours ) etc. !_12 Hours maximum.
START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer setting
as folIows: 1 Hour Ip2 Hours Ip etc. _. 12 Hours maximum.
POWER
•To turntheairconditionerON,pushthebutton.To turntheair
conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan
speed, Temperature setting at 72°F.
FAN SPEED
• Everytimeyoupushthisbutton,it advancesthesettingas
follows: {High(F2) _. Low(F1) _,High(F2)}
In failure of electric power, the unit runs as previous setting operation.
-10-
Loading ...
Loading ...
Loading ...