Loading ...
Loading ...
Loading ...
5
Controls
Button Function Display
A
Turns the suction motor on and off at speed
one.
Displays the set speed
B
Decreases the working speed. Displays the set speed
C
Increases the working speed. Displays the set speed
D
Activates Intensive speed from any other speed,
including motor off. This speed is set to operate for 6
minutes, after which the system returns to the speed that
was set before. Suitable to deal with maximum levels of
cooking fumes.
Displays HI and the time remaining once every
second.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on/off.
FC+Dot
FC+Dot
E
24H function
Turns the motor on at speed one and effects one 10
minute extraction every hour.
Displays 24
once a second, while the motor is running. It is
disabled by pressing the button.
by pressing and holding this button for approximately
3 seconds. These indications are only visible when the
motor is turned off.
FF
When the procedure terminates, the indication
shown previously turns off:
FG indicates the need to wash the metal grease
!
been in operation for 100 working hours.
FC indicates the need to change the activated
"
!
been in operation for 200 working hours.
F
Delay function
Activate automatic switch-off with a 30’ delay. Suitable
to complete elimination of residual odours. It can be
activated from any position and is deactivated by pressing
the button or turning the motor off.
This mode does not function if Intensive or 24h is active.
Displays the operating speed and the dot at the
G
Turns the lighting system on and off at maximum
intensity.
H
Turns the lighting system on and off in Courtesy Light
mode.
On start-up the board recognises the mains frequency.
Recognition is indicated on the display:
- 50Hz: the display will show “50” for one second
- 60Hz: the display will show “60” for one second
Loading ...
Loading ...