Loading ...
Loading ...
Loading ...
Replacing the reversing lamp and inner
brake lamp
1. Loosen the bottom holder, arrow 1.
2. Loosen the top holder, arrow 2. To do so,
press in the middle latch and then press
out both outside latches.
Remove the lamp holder, arrow 3.
3. Unscrew the defective bulb of the revers‐
ing or brake lamp from its socket counter‐
clockwise.
4. Insert the new bulb.
Installing the bulb holder
1.
Insert the two contacts, arrow 1, into the
connections, arrow 2.
2. Press on the bulb holder, arrow 3. Make
sure that the two exterior holders latch into
place.
3. Reattach the two covers to the trunk lid.
Rear lamp, license plate lamp and
central brake lamp
Follow general instructions, refer to page 190.
These lights are made using LED technology.
Contact your service center in the event of a
malfunction.
Changing wheels
Hints
When sealants are used, an immediate wheel
change when there is a loss of tire inflation
pressure in the event of a flat tire is unneces‐
sary.
Which is why no spare tire is available.
The tools for changing wheels are available as
accessories from your service center.
Jacking points for the vehicle jack
The jacking points for the vehicle jack are lo‐
cated at the positions shown.
Vehicle battery
Maintenance
The battery is maintenance-free.
Further information about the battery can be
obtained from your service center.
Battery replacement
Use approved vehicle batteries only
Only use vehicle batteries that have been
approved for your vehicle by the manufacturer;
otherwise, the vehicle could be damaged and
Seite 195
Replacing components Mobility
195
Online Edition for Part no. 01 40 2 960 812 - II/15
Loading ...
Loading ...
Loading ...