Loading ...
Loading ...
Loading ...
Problem Possible cause Solution
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The "FastFreeze function" is
switched on.
Switch off "FastFreeze func-
tion" manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "FastFreeze function"
section.
The temperature in the appli-
ance is too low/too high.
The temperature is not set cor-
rectly.
Set a higher/lower tempera-
ture.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The food products' tempera-
ture is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened of-
ten.
Open the door only if necessa-
ry.
The FastFreeze function is
switched on.
Refer to "FastFreeze function"
section.
There is no cold air circulation
in the appliance.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.
Power indicator light flashes. An error has occurred in meas-
uring the temperature.
Contact a qualified electrician
or the nearest Authorized
Service Centre.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
13
Loading ...
Loading ...
Loading ...