Loading ...
Loading ...
Loading ...
11
TROUBLESHOOTING
If you experience Possible Causes Solution
Clothes are not drying
satisfactorily, drying
times are too long
Lint screen clogged with lint. Lint screen should be cleaned before each load.
The Air Only cycle has been selected. Select the right cycle for the types of garments being dried.
See “Cycle Guide.”
Load too large and heavy to dry quickly. Separate the load to tumble freely.
Exhaust vent or outside exhaust hood
clogged with lint, restricting air movement.
Run the dryer for 5–10 minutes. Hold your hand under the
outside exhaust hood to check air movement. If you do not feel
air movement, clean exhaust system of lint or replace exhaust
vent with heavy metal or exible metal vent. Make sure vent
is not crushed or kinked. See Installation Instructions.
Fabric softener sheets blocking the grill. Use only one fabric softener sheet, and use it only once.
Exhaust vent not the correct length. Check that the exhaust vent is not too long or has too many
turns. Long venting will increase drying times. Make sure vent
is not crushed or kinked. See Installation Instructions.
Exhaust vent diameter not the correct size. Use 4" (102mm) diameter vent material.
Dryer located in a room with temperature
below 45ºF (7ºC).
Proper operation of dryer cycles requires temperatures above
45ºF (7ºC).
Dryer located in a closet without adequate
openings.
Closet doors must have ventilation openings at the top and
bottom of the door. The front of the dryer requires a minimum
of 1" (25mm) of airspace, and, for most installations, the rear
of the dryer requires 5" (127mm). See Installation Instructions.
Dryer will not run Door not closed completely. Make sure the dryer door is closed completely.
PUSH to START button not pressed rmly
or held long enough.
Press and hold the PUSH to START button until you hear the
dryer drum moving.
Household fuse is blown or circuit breaker
has tripped.
Electric dryers use 2 household fuses or circuit breakers. The
drum may be turning, but you may not have heat. Replace both
fuses or reset the circuit breaker. If the problem continues, call
an electrician.
Incorrect power supply. Electric dryers require 240-volt power supply. Check with a
qualied electrician.
Wrong type of fuse. Use a time-delay fuse.
Unusual sounds Dryer had a period of non-use. If the dryer hasn’t been used for awhile, there may be a
thumping sound during the rst few minutes of operation.
A coin, button, or paper clip is caught
between the drum and front or rear of the
dryer.
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
It is a gas dryer. The gas valve clicking is a normal operating sound.
The four legs are not installed, and the
dryer is not level front to back and side
to side.
The dryer may vibrate if not properly installed. See Installation
Instructions.
Clothing knotted or balled up. When balled up, the load will bounce, causing the dryer
to vibrate. Separate the load items and restart the dryer.
No heat Household fuse is blown or circuit breaker
has tripped.
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace both
fuses or reset the circuit breaker. If the problem continues, call
an electrician.
Supply line valve not open. For gas dryers, be sure the valve on the supply line is open.
Incorrect power supply. Electric dryers require 240-volt power supply. Check with
a qualied electrician.
Loading ...
Loading ...
Loading ...