Loading ...
Loading ...
Loading ...
15
ICE TYPE
You can select water or ice.
• Select Water, Crushed Ice or Cubed Ice by
pressing the ICE TYPE button to the selection
desired. The Water, Crushed Ice or Cubed Ice icon
will light up to indicate selection.
Light up the cubed ice lamp by pressing the
selection button. The icon will be illuminated.
Light up the water lamp by pressing the
selection button.he icon will be illuminated.
Light up the crushed ice lamp by pressing the
selection button. The icon will be illuminated.
To dispense water or ice, gently push your cup against
the dispenser pad.
NOTE: Hold your cup in place for a couple of seconds
after dispensing ice or water so the last few
drops go in your cup instead of on the oor.
DOOR ALARM
When either refrigerator or freezer door is left open for
more than 60 seconds, an alarm will sound 5 times at
thirty-second intervals to let you know the door is open.
The alarm will repeat every 30 seconds until all doors
are completely closed.
Please contact the local service center if warning tone
continues to sound even after closing the door.
FILTER
(Filter replacement cycle)
There is an indicator light for the water filter cartridge
on the dispenser that will blink to indicate it is time to
change the water filter. Water filters usually need to be
replaced once every six months. After replacing the
filter, press and hold the Filter Reset button for 3
seconds to turn off the filter status light.
LOCK
The Lock button deactivates the temperature controls
and dispenser functions.
Press and hold this button for 3 seconds or until the
Lock indicator light is lit.
To disable the Lock function, press and hold the filter
button for seconds or until the Lock indicator light is
off.
ICE PLUS
Press this button once to activate the increased ice
making function. The ICE PLUS icon on the display
panel will illuminate when activated. The Ice Plus
function runs the freezer compartment at the coldest
settings for a 24 hour period to increase ice making.
Press the button again to cancel the Ice Plus function.
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely
before making final adjustments. It is best to wait 24
hours before doing this. The initial settings mentioned
in CONTROL PANEL FEATURES section should be
correct for normal household refrigerator use.
The refrigerator control functions as the thermostat for
the entire appliance (refrigerator and freezer sections).
The colder the setting, compressor will the longer the
run to keep the temperature colder. The freezer control
adjusts the cold air ow from the freezer to the
refrigerator. Setting the freezer control to a lower
temperature keeps more cold air in the freezer
compartment to make it colder.
If you need to adjust temperatures in the refrigerator
or freezer, start by adjusting the refrigerator and allow
24 hours for the temperature to stabilize. If it is too
warm or too cold, then adjust the freezer control. Use
the settings listed in the chart below as a guide. Always
remember to wait at least 24 hours between
adjustments.
CONDITION/REASON: RECOMMENDED
ADJUSTMENT:
REFRIGERATOR section too
warm
–Door opened often
–Large amount of food added
–Room temperature very
warm
Set the Refrigerator
control to the next
colder level; wait 24
hours for the new
setting to take full
effect before
making another
adjustment.
FREEZER section too warm/
ice not made fast enough
–Door opened often
–Large amount of food added
Very cold [room 55°F (13°C)]
room temperature
(Compressor does not cycle
often enough).
–Heavy ice usage
–Air vents blocked by items
Set the Freezer
control to the next
colder level; wait 24
hours for the new
setting to take full
effect before making
another adjustment.
Move items out of
airstream
REFRIGERATOR section too
cold
–Controls not set correctly for
your conditions
Set the Refrigerator
control to the next
warmer level; wait 24
hours for the new
setting to take full
effect before
making another
adjustment.
FREEZER section too cold
–Controls not set correctly for
your conditions
Set the Freezer
control to the next
warmer level; wait 24
hours for the new
setting to take full
effect before
making another
adjustment.
USING YOUR REFRIGERATOR
CUBE
Loading ...
Loading ...
Loading ...