Loading ...
Loading ...
Loading ...
To replace crisper cover:
1. Fit back of cocer frame into supports on side walls of
the refrigerator
2. Lower front of the cover frame into place.
3. Slide rear of glass insert into cover frame and lower
front into place.
Door Rails
The door rails may be removed for easier cleaning.
Snap-on Door Rails
To rem ove the rails:
1. Remove all items from the shelf.
2. Push in slightly on the front of the bracket while pulling
out on the inside tab.
3. Repeat these steps for the other end of the rail.
To replace the rails:
1. Line up the ends of the brackets with the buttons on the
sides of the door liner.
2. Firmly snap bracket and rail assembly onto the tabs
above the shelf as shown.
Drop-in Door Rails
To rem ove the rails:
1. Remove all items from the shelf.
2. Pull straight up on each end of the rail.
To replace the rails:
1. Slide the shelf rail into the slots on the door.
2. Push the rail straight down until it stops.
Ice Maker Operation
(on some models)
After the freezer section reaches normal freezer
temperature, the ice maker fills with water and begins
forming ice. Allow 24 hours to produce the first batch of
ice. Ice maker should then produce approximately 7 to 9
batches of ice in a 24 hour-period. Discard the first three
batches of ice produced.
After ice is made, the ice cubes drop into the storage bin.
When ice storage bin is full, ice maker arm raises to the
OFF position (arm up). If ice is not needed, you can stop
the ice maker by raising the arm to the OFF position (arm
up). Listen for a click sound to be sure that the ice maker
will not continue to operate.
To start ice maker, lower arm to the ON position (arm
down). Do not force arm up or down. Do not store anything
on top of the ice maker or in the ice storage bin.
■ The ON/OFF lever for the ice maker is a wire signal arm
located on the side of the ice maker. Push the arm
down to start making ice automatically, and push it up
to shut off the ice maker.
■ It is normal for the ice cubes to be attached at the
corners. They will break apart easily.
■ The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as overnight.
■ If ice is not being made fast enough and more ice is
needed, turn the Freezer Control toward a higher
(colder) number in half number steps. (For example, if
the control is at 3, move it to between 3 and 4.) Wait 24
hours and, if necessary, gradually turn the Freezer
Control to the highest setting, waiting 24 hours between
each increase.
REMEMBER:
■ The quality of your ice will be only as good as the
quality of the water supplied to your ice maker.
■ Avoid connecting the ice maker to a softened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be avoided, make
sure the water softener is operating properly and is well
maintained.
16
Loading ...
Loading ...
Loading ...