Loading ...
Loading ...
Loading ...
13
DRYER VENTING REQUIREMENTS
To reduce the risk of re, this dryer MUST BE
EXHAUSTED OUTDOORS.
Observe all governing codes and ordinances.
Dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling, ac, crawlspace, or a concealed space
of a building. Only rigid or exible metal vent shall be used for
exhausng.
■ Only a 4" (102 mm) heavy, metal exhaust vent and clamps
may be used.
■ Do not use plasc or metal foil vent.
■ Recommended for best drying performance and to avoid
crushing and kinking.
(Acceptable only if accessible to clean)
■ Must be fully extended and supported in nal dryer
locaon.
■ Remove excess to avoid sagging and kinking that may result
in reduced airow and poor performance.
■ Do not install in enclosed walls, ceilings, or oors.
■ The total length should not exceed 7
3
⁄
4
. (2.4 m).
If using an exisng vent system, clean lint from enre
length of the system and make sure exhaust hood is not
plugged with lint. Replace plasc or metal foil vents with rigid
metal or exible metal vents. Review “Vent System Chart” and
if necessary, modify exisng vent system to achieve best drying
performance.
4"
(102 mm)
4" (102 mm) heavy, metal exhaust vent
■ 45° elbows provide beer airow than 90° elbows.
■ Use clamps to seal all joints.
■ Exhaust vent must not be connected or secured with screws
or other fastening devices that extend into interior
of duct and catch lint. Do not use duct tape.
Improper venting can cause moisture and lint to collect
indoors, which may result in:
Moisture damage to woodwork, furniture, paint, wallpaper,
carpets, etc.
Housecleaning problems and health problems.
Better
Good
Loading ...
Loading ...
Loading ...