Loading ...
Loading ...
Loading ...
CLEANING
FIG. 6
5
IMPORTANT:
always disconnect the appliance from the gas and electricity mains before carrying out any cleaning
operation.
2) HOT PLATE
Periodically wash the hot plate, the enamelled steel pan support, the enamelled burner caps “C” and the
burner heads “M” (see fig. 6) with lukewarm soapy water. Following this, all parts should be thoroughly
rinsed and dried. Never wash them while they are still warm and never use abrasive powders. Do not allow
vinegar, coffee, milk, salted water, lemon or tomato juice from remaining in contact with the enamelled
surfaces for long periods of time.
WARNINGS:
comply with the following instructions, before remounting the parts:
- check that burner head slots “T” (fig. 6) have not become clogged by foreign bodies.
- Check that enamelled burner cap “C” (fig. 6) have correctly positioned on the burner head. It must
be steady.
- The exact position of the pan support is established by the rounded corners, which should be set
towards the side edge of the hot plate.
- Do not force the taps if they are difficult to open or close. Contact the technical assistance service
for repairs.
- Don’t use steam jets for cleaning the cooktop.
CARE & MAINTENANCE
To optimize the appearance and upkeep of stainless:
1) ALWAYS keep stainless steel out of contact from Acid/Acid based solvent (liquid or vapour form).
2) After installation, wipe clean all stainless steel products with a soft damp cloth to remove any traces of dirt
(e.g. cement dust) or condensation marks.
In the event whereby persistant sparks appear:
immediately clean affected areas with stainless steel cleaner, using a clean damp soft cloth.
Ensure surface is rinsed and thoroughly clean of all marks and cleaning agent.
PREVENTATIVE MAINTENANCE
This cooktop should not require ongoing maintenance provided you ensure:
- all spillages are cleaned up as soon as they occur.
- Burners are kept clean.
- Burner ports are free of debris, food or anything else that may cause an obstruction.
- Electrode and thermocouples are kept clean.
- Burners are re-assembled correctly.
- Do not get water in the area where the injectors are located.
Loading ...
Loading ...
Loading ...